Yes, the famous franchises will remain the selling point for many a LEGO fan, but for those who spent years of their childhood sitting in their lounges or bedrooms building hospitals – nay, worlds – LEGO City is everything that you could need. And for a set such as this to bring back your childhood, as well as give you a thoroughly enjoyable build experience – and the added bonus of seeing a new generation of excited faces – this is a must-have set and worth every penny.
Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.
Every good airport needs a hangar for the planes, and this is no exception. The satisfactory hangar included here does come across as rather basic, and while it doesn’t detract from the overall package, it isn’t going to swing your decision over whether to purchase this (and truthfully, I think you would have already made that decision before you come to the hangar). The design itself is simple, with the build unlikely to take you more than 10 minutes. That being said, it is a well-built piece and doesn’t feel flimsy, which was the impression I had when I first saw a picture of it. The criss-cross pieces towards the base give it a firm foundation, and there are plenty of long pieces which add further stability to it. Plane-wise, it is best suited for the old-fashioned vehicle, with the orange colouring in the design going well with the plane. Only a couple of stickers in use here, with just the AIRSHOW HANGAR words needing to be added.
With a price tag of £69.99/$79.99 and a piece count of 807 it means you’re paying roughly 8-9p/9-10cents per piece, which isn’t too bad when you look at it that way. This set is also quite unique in that it contains the spoilerific Giant Man brick built figure. Also in the set is the airport control tower, a baggage car and a smaller version of the Quinjet.
I did prefer the previous 3182 airport set as it had a lot more components. But, I realise that it makes more business sense to offer a little less than raise the price of an already expensive product. However, 60104 is still a nice set and is often very well discounted in the UK so, I ordered a pallet load from Tesco during their 3-for-2 which made them a half-priced no-brainer ;-)
This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.
Agent 13 has a pretty plain appearance, with caramel-coloured wavy hair, and a black, spy-like top. Her torso has some nice details, with sharp, angular lines that all combine to form a rough outline of an upside down star. She has plain sand blue pants and rocks a sub-machine gun accessory. I like regular LEGO firearms, so it’s very nice to get one in this set as they’re fairly uncommon.