Airport Passenger Terminal with control tower and conveyor belt measures over 11” high, 12” wide and 4” deep. Airplane measures over 7” high, 18” long and 19” wide. Service car measures over 1” high, 2” long and 1” wide. Luggage trailer measures over 3" long, 1" high and 1" wide. Fuel trailer measures over 1” high, 3” long and 1” wide. Mobile stairway measures over 2” high, 2” long and 1” wide
The main wings are made up of a pair of white 10 x 10 wedge plates with cut corner and no studs in the centre; these are rare, having only previously appeared in two sets in this colour. The red 1 x 1 plate with tooth on each wing tip is also uncommon, having appeared in less than ten sets to date. The sides of the cockpit are made up of stickered red 1 x 4 x 1 panels, and it definitely helps if you concentrate when you apply the stickers, which I clearly didn’t as you can see in the picture below…. The area behind the cockpit canopy is nicely contoured by a red 4 x 4 triple wedge which, I was surprised to discover, has only previously appeared in a single set in this colour. Not to be outdone, however, the large 12 x 2 x 5 tail is appearing for the very first time in red. The hinged trans-black cockpit canopy is yet another rare element, appearing here for only the second time ever; rare it might be, but its pronounced curvature unfortunately means that it somewhat spoils the hitherto sleek lines of the jet. The flipside of this, however, is that the cockpit can comfortably accommodate the pilot.

Last to be assembled is the hangar, which given its size is a surprisingly quick build – even though I’m a notoriously slow builder it took me barely ten minutes to put it together. The first step involves stacking dark bluish grey and orange plates and tiles to create a three-sided enclosure covering an area of 24 x 32 studs. Two side walls are then constructed from 1 x 6 x 5 rectangular girders topped off with dark bluish grey bricks and orange tiles, after which the roof is assembled, predominantly from a few large plates including a black 8 x 16 plate only previously available in two sets, and four dark bluish grey 6 x 24 plates which are only appearing in a set for the second time ever. A couple of stickers at the front of the structure identify it as an Airshow Hanger; to be frank, describing it as a hanger is probably exaggerating the case a bit as with its open front and rear it’s more akin to a large shelter.
@josekalel: I think the size of the terminal is kept in check for price reasons more than anything. This is a $100 set, and while bigger and pricier City sets exist, they tend to be few in number. What's more, the disadvantage to having a plane wide enough to seat two rows of passengers is that it inevitably takes up a big portion of the budget even for a larger set like this one. If the set were just the airport with no plane, then the terminal could probably be around twice this size at the very least… but then the set would not offer such a complete play experience.
Here’s a look at the Winter Soldier and Captain America minifigures. Unfortunately, neither one of them is exclusive to this set, with this version of Winter Soldier making an appearance in 76047 Black Panther Pursuit. Captain America has been a lot more promiscuous, having made an appearance in 2 sets (Quinjet City Chase & Hydra Fortress Smash) and a polybag as well. His torso is also identical to the one from Black Panther Pursuit.
While I like their characters, I really don’t like LEGO recycling their characters. I can make an exception for Bucky, who until this year has only been made available as a pretty exclusive (and pricey) polybag but having this exact same Captain America show up in so many sets is pretty damn lazy. If a super hero minifig has been used a year ago, it really isn’t too much to ask for LEGO to update it slightly.
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
×