The construction of the new airport was carried out during 1964 and the airport opened on 1 November, with one runway at 1660 meters in length and 45 meters width, a small platform where aircraft could be served, and a control tower to the controller. Hans Erik Christensen, the former chief pilot at LEGO became director, and the passengers were handled in LEGO's hangar until the first terminal building was opened in the spring of 1966. The airport was continuously expanded the following years, with new facilities, terminal buildings, lounge, tax-free area and hangars where LC Johansen's studio often participated as an architect (today called the Johannsen Architects), while other work was carried out by the airport's own studio.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
LEGO City enables us all to remember why we fell in love with LEGO to begin with, to remember how we all first became exposed to LEGO; as a little kid, building our first house or giving our minifigures a hospital or a police station to work in. My first set was a garage, quickly followed by a police station. Having recently found these in storage, and keen to rebuild them, having the opportunity to build something not revolving around a Jedi or an Avenger is one I keen to take advantage of.

Parking capacity at Copenhagen Airport was greatly expanded in 2015 with the construction of a new lot as one of the first phases in an ambitious airport expansion plan scheduled to roll out in the coming decades. There are several lots: those near the terminals are very expensive, while the further-flung ones are cheaper (but have free shuttle bus service to the terminals).