Yes, the famous franchises will remain the selling point for many a LEGO fan, but for those who spent years of their childhood sitting in their lounges or bedrooms building hospitals – nay, worlds – LEGO City is everything that you could need. And for a set such as this to bring back your childhood, as well as give you a thoroughly enjoyable build experience – and the added bonus of seeing a new generation of excited faces – this is a must-have set and worth every penny.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
Pack your bags and get ready to go on vacation! Head to the airport and check in at the terminal. Put your luggage on the conveyor belt and watch it get loaded onto the passenger airplane. Go through security and then head out the revolving doors to the loading area. Climb the stairs and get buckled in, your trip is about to start! This creative play building toy includes 6 minifigures.
@josekalel: I think the size of the terminal is kept in check for price reasons more than anything. This is a $100 set, and while bigger and pricier City sets exist, they tend to be few in number. What's more, the disadvantage to having a plane wide enough to seat two rows of passengers is that it inevitably takes up a big portion of the budget even for a larger set like this one. If the set were just the airport with no plane, then the terminal could probably be around twice this size at the very least… but then the set would not offer such a complete play experience.
Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.
The latest wave of City sets takes us to the airport, for a wide selection of aerial adventures. Whether it’s delivering the mail, or making sure a VIP gets to where they need to go, the LEGO City Airport range has a wide selection available. With five sets of varying prices, there truly is something for everyone here. The Airport Air Show – which we are looking at today – offers two stunt jets and a vintage plane – as well as a hangar and the staff required to keep things ticking over.
Since the 1950s, the Lego Group has released thousands of sets with a variety of themes, including space, robots, pirates, trains, Vikings, castle, dinosaurs, undersea exploration, and wild west. Some of the classic themes that continue to the present day include Lego City (a line of sets depicting city life introduced in 1973) and Lego Technic (a line aimed at emulating complex machinery, introduced in 1977).
LEGO City enables us all to remember why we fell in love with LEGO to begin with, to remember how we all first became exposed to LEGO; as a little kid, building our first house or giving our minifigures a hospital or a police station to work in. My first set was a garage, quickly followed by a police station. Having recently found these in storage, and keen to rebuild them, having the opportunity to build something not revolving around a Jedi or an Avenger is one I keen to take advantage of.
@DrDave : My thoughts were not that the hangar should be big enough to hold *all* aircraft simultaneously - which would, indeed, make it huge! - but that it should at least be big enough to hold any one of them. Just a few studs wider should cover the wingspan of either jet (judging from the photos). Add a few centimetres to the height - by whatever construction means - and that'll accommodate the oversized tail on the Viggen-styled plane. If/when I pick up this set, that's the mods I'll be making to it.
Bag 7 finished off the front facade adds in a metal detector and the baggage check-in station. I guess you enter from the right and then maybe the revolving doors are where you can walk out to the plane. I'm not really sure anymore. The conveyor belt is a nice addition to the set for playability and is set up so you can pull the baggage cart right next to it.
Inside the box we find eight numbered bags, two unnumbered bags containing large molded plane parts, two loose 16x16 plates, the large airplane wing in medium grey, a sticker sheet and four instruction booklets of varying sizes. Unfortunately there is no cardboard to keep the booklets and sticker sheet flat (though fortunately mine were not crumpled), but never fear, there is a brick separator!
The build itself is good fun, as it should be, and engaging enough to be interesting. The only thing that I started to find a little boring was the Airport Control Tower, but then its top redeemed it. Naturally, the best thing to build is the Giant Man figure. The techniques used to make it posable, like a regular Lego minifigure, were brilliantly thought out. I hope to see more like this, perhaps in a Galactus set, although I doubt that’ll ever happen.
The construction of the new airport was carried out during 1964 and the airport opened on 1 November, with one runway at 1660 meters in length and 45 meters width, a small platform where aircraft could be served, and a control tower to the controller. Hans Erik Christensen, the former chief pilot at LEGO became director, and the passengers were handled in LEGO's hangar until the first terminal building was opened in the spring of 1966. The airport was continuously expanded the following years, with new facilities, terminal buildings, lounge, tax-free area and hangars where LC Johansen's studio often participated as an architect (today called the Johannsen Architects), while other work was carried out by the airport's own studio.
Play out real-life scenarios in LEGO DUPLO Town: a recognizable world with modern DUPLO figures. Help your little pilot get ready for take-off at the LEGO DUPLO Airport! It's easy for preschoolers to build the boarding gate, luggage slide and revolving air traffic control tower. Makes an ideal gift for preschool children. Contains 29 pieces. Airport measures over 8 (22cm) high, 5 (14cm) wide and 4 (11cm) deep. Plane measures over 3 (9cm) high, 7 (18cm) long and 6 (17cm) wide.
The Lego Movie, a feature film based on Lego toys, was released by Warner Bros. in February 2014. It featured Chris Pratt in the lead role, with substantial supporting characters voiced by Will Arnett, Morgan Freeman, Liam Neeson, Alison Brie, Will Ferrell and Nick Offerman. A contest was held for contestants to submit designs for vehicles to be used in the film. After the release of The Lego Movie, independent Canadian toy retailers reported issues with shortages of Lego products and cited cancellations of Lego pre-orders without warning as a motive to stock compatible, rival products.
Every good airport needs a hangar for the planes, and this is no exception. The satisfactory hangar included here does come across as rather basic, and while it doesn’t detract from the overall package, it isn’t going to swing your decision over whether to purchase this (and truthfully, I think you would have already made that decision before you come to the hangar). The design itself is simple, with the build unlikely to take you more than 10 minutes. That being said, it is a well-built piece and doesn’t feel flimsy, which was the impression I had when I first saw a picture of it. The criss-cross pieces towards the base give it a firm foundation, and there are plenty of long pieces which add further stability to it. Plane-wise, it is best suited for the old-fashioned vehicle, with the orange colouring in the design going well with the plane. Only a couple of stickers in use here, with just the AIRSHOW HANGAR words needing to be added.
I’m pleased to report that I thoroughly enjoyed building this set, and what’s more I quite enjoyed playing with it afterwards as well…. First and foremost it’s an excellent play set – it’s not often that you get three good-sized vehicles plus a large building and a number of accessories in a single set at this price point. Furthermore, all three aircraft are actually pretty good, particularly the two jets which look really sleek apart from their prominent cockpit canopies. The jets are also solidly built, surprisingly weighty, and eminently swooshable; you can conveniently grab them by their lateral air intakes and nothing falls off when you swoosh them around - I know this as I extensively tested this particular play feature…. The hanger is admittedly a bit insubstantial, but overall this set lived up to my expectations and I’ll certainly be picking up a couple more of the Airport sets this summer.
^ Jump up to: a b Alexander, Ruth (3 December 2012). "How tall can a Lego tower get?". BBC News. Archived from the original on 4 December 2012. Retrieved 4 December 2012. The average maximum force the bricks can stand is 4,240N. That's equivalent to a mass of 432 kg (950lbs). If you divide that by the mass of a single brick, which is 1.152g, then you get the grand total of bricks a single piece of Lego could support: 375,000. So, 375,000 bricks towering 3.5 kilometers (2.17 miles) high is what it would take to break a Lego brick.
The mechanic is a rather basic design, with an all-blue colour and a work shirt pattern. He comes equipped with a walkie-talkie and a full tool truck, containing every piece of equipment a mechanic could need. The airport worker looks like every other workman from The LEGO Movie that joined Emmet in a chorus of Everything is Awesome, and is a nostalgic hark bark to the old construction figures that I grew up playing with.
The final two minifigures are the Biplane Pilot and the intrepid Wing Walker. Both of these minifigures share the same white torso which is printed with a flight suit design overlaid with dark red and bright light orange flames plus a logo over the left breast. The torso design is superb and it can at present only be found in this set. Both minifigures are provided with a reddish brown aviator cap and dark bluish grey goggles, and the pilot (below left) also gets an alternative to this headgear in the form of medium dark flesh mid-length hair which has only ever appeared in five sets in this colour.