Play out real-life scenarios in LEGO DUPLO Town: a recognizable world with modern DUPLO figures. Help your little pilot get ready for take-off at the LEGO DUPLO Airport! It's easy for preschoolers to build the boarding gate, luggage slide and revolving air traffic control tower. Makes an ideal gift for preschool children. Contains 29 pieces. Airport measures over 8 (22cm) high, 5 (14cm) wide and 4 (11cm) deep. Plane measures over 3 (9cm) high, 7 (18cm) long and 6 (17cm) wide.
The set has an impressive assortment of minifigures - I quite like that it has six, allowing for a lot of play opportunities. All the major parts of the plane - the wing, cockpit, tail and body - are new to this set in their colours. The inside of the plane has a minimal amount of details, with five seats, a galley and a lavatory. The outside of the plane looks quite smart with all the stickers applied.
There are 3 cardboard boxes with more Easter eggs. We get a few references to Marvel organisations such as A.I.M., who you may remember from Iron Man 3 as an R&D agency run by Aldrich Killian, Hammer, one of Stark Industries primary rivals which made an appearance in Iron Man 2, bankrolling Whiplash and finally a box with the Stark Industries logo on it.
The body of the plane is built with five seats for passengers. The wings are added next with what I think are filler stickers added to the top of the wings. There is a small galley with sink and oven in the front of the plane right behind the cockpit. The cockpit uses only one sticker to show navigation equipment - the other is printed, which is always welcome (though not a new piece). A lavatory is installed in the back, and then the inside is complete. There is an odd choice for the door to the lav - a swinging door. Not much opportunity for privacy!
Frequently Asked Questions | About Brickset | Privacy and Cookies | Affiliate Marketing Disclosure | Site Map | Contact Us LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2018 The LEGO Group. Brickset, the Brickset logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©1997-2018 Brickset ltd.
The latest wave of City sets takes us to the airport, for a wide selection of aerial adventures. Whether it’s delivering the mail, or making sure a VIP gets to where they need to go, the LEGO City Airport range has a wide selection available. With five sets of varying prices, there truly is something for everyone here. The Airport Air Show – which we are looking at today – offers two stunt jets and a vintage plane – as well as a hangar and the staff required to keep things ticking over.
The railway station, 1 Københavns Lufthavn, Kastrup Station (sometimes called CPH Airport Station and wrongly Kastrup Station), is located in Terminal 3. The station has frequent connections to Copenhagen and Malmö, as well as InterCity trains for the rest of Denmark and a few daily SJ 2000 express trains for Stockholm. The frequent Øresund trains between Copenhagen and Malmö continue in Denmark to Elsinore and in Sweden to a number of destinations in Scania and other parts of Götaland. The travel time to Copenhagen Central Station is 12 minutes, and 20 minutes to Malmö Central Station.
Basically, the only thing that the two sets have in common is that they both have planes. However there is quite a bit of difference on the inside of the planes. There are a lot more details in the Friends plane. In addition to the seats, there is a rolling service cart complete with refreshments, emergency lighting as well as a larger galley and lav in the back of the plane.
The two stunt jets included here actually have some similarity in the basic design and colour scheme to the main piece seen in the Marvel Super Heroes Avenjet Space Mission set. With that being said, I loved the Avenjet in that particular set, so any similarity holds no issue with me. The red and white colours work really well together, and it looks like something you would genuinely see flying through the sky at an air show. I really love it when LEGO truly capture the essence of what you are building, and they do that here. The jets themselves, as I said before, are similar to previously-released jets, and therefore the builds won’t come as any main surprise. That shouldn’t detract from the product, however, as it is a prime example of LEGO finding a winning formula and not really needing to change it.
Other airlines offering intercontinental connections to Copenhagen are SAS's Star Alliance partners Singapore Airlines (to Singapore), Air Canada (to Toronto) and Thai Airways (to Bangkok Suvarnabhumi and Phuket), as well as competing SkyTeam carrier Delta with a seasonal connection to JFK and Pakistan International Airlines to Islamabad and Lahore.
A minifigure can comfortably fit seated inside the cockpit, and it is here that I found the first issue with the set. I had no issue inserting and removing the figure from his seated position, but my seven-year old struggled to get him out, deciding to leave him onboard instead of disembarking after she brought the jet back into the hangar. The physical connection between LEGO pieces in the cockpit and the pilot minifigure didn’t seem to present an issue, so whether or not this was just a one-off issue remains to be seen.
Almost all major European carriers have a connection to Copenhagen from their main hubs. As Denmark holds sizable immigrant communities from various European countries, even smaller carriers have frequent connections to the likes of Sarajevo or Belgrade. Copenhagen Airport has been seeing increased traffic from low-fare carriers since the launch of the dedicated CPH Go section of the airport (with common check-in and security with other airlines, but separate gates and waiting area). Airlines using CPH Go include EasyJet, Ryanair, Transavia, and WizzAir, although the latter only for selected destinations, with the majority of its flights to the Øresund area landing at Malmö Sturup Airport instead.
Bag 4 finishes the fuselage and all that is left are the engines and tail section. You'll notice that this aircraft has a bathroom on board as well as some storage for a non-existent flight attendant. I think this is the first time that LEGO has put some additional details into aircraft besides just seats. Also there is only one pilot for a 2 seat cockpit in the set.
^ Jump up to: a b Alexander, Ruth (3 December 2012). "How tall can a Lego tower get?". BBC News. Archived from the original on 4 December 2012. Retrieved 4 December 2012. The average maximum force the bricks can stand is 4,240N. That's equivalent to a mass of 432 kg (950lbs). If you divide that by the mass of a single brick, which is 1.152g, then you get the grand total of bricks a single piece of Lego could support: 375,000. So, 375,000 bricks towering 3.5 kilometers (2.17 miles) high is what it would take to break a Lego brick.
Bag 3 starts the aircraft and includes 3 minifigures (2 passengers and a pilot) The aircraft has the standard wings and fuselage sections. I am not a fan of the giant wing piece as it limits the number of seats. It does however help to make the aircraft more realistic. Given the size of the aircraft, there are only 5 seats for passengers which is rather disappointing.
The Lego Group began in the workshop of Ole Kirk Christiansen (1891–1958), a carpenter from Billund, Denmark, who began making wooden toys in 1932. In 1934, his company came to be called "Lego", derived from the Danish phrase leg godt, which means "play well". In 1947, Lego expanded to begin producing plastic toys. In 1949 Lego began producing, among other new products, an early version of the now familiar interlocking bricks, calling them "Automatic Binding Bricks". These bricks were based on the Kiddicraft Self-Locking Bricks, which had been patented in the United Kingdom in 1939 and released in 1947. Lego had received a sample of the Kiddicraft bricks from the supplier of an injection-molding machine that it purchased. The bricks, originally manufactured from cellulose acetate, were a development of the traditional stackable wooden blocks of the time.
LDStructure, developed by Michael Heidemann, is a tool for analyzing ldraw parts library. With LDStructure you will get a tool that tells you which parts are required to show the current part and where the current part is used in. You will get this information within a second or even quicker. So this tool is a "needs to have" if you are working on parts for the ldraw part library.
The final two minifigures are the Biplane Pilot and the intrepid Wing Walker. Both of these minifigures share the same white torso which is printed with a flight suit design overlaid with dark red and bright light orange flames plus a logo over the left breast. The torso design is superb and it can at present only be found in this set. Both minifigures are provided with a reddish brown aviator cap and dark bluish grey goggles, and the pilot (below left) also gets an alternative to this headgear in the form of medium dark flesh mid-length hair which has only ever appeared in five sets in this colour.