The upper and lower wings are connected by a dark bluish grey 4 x 1 x 3 tail on either side; this tail element is unique to the set in this colour, although has previously appeared in a couple of sets back in 2003 in old dark grey. The upper wing is also supported by a couple of 1 x 2 x 2 black windows placed back to back in front of the cockpit, which from the perspective of the pilot really can’t be good for visibility. The biplane has a three blade propeller and the tips of the blades are stickered prior to sliding the propeller on to a 6L axle protruding from the front of the fuselage where it’s held in place by an orange 2 x 2 brick with domed top. The last step is to attach a 1 x 4 x 2 bar to the top of the upper wing for the Wing Walker to hold on to and then we’re done with the biplane.
Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.