This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
In June 2013, it was reported that Warner Bros. was developing a feature film adaptation of Lego Ninjago. Brothers Dan Hageman and Kevin Hageman were attached to write the adaptation, while Dan Lin and Roy Lee, along with Phil Lord and Chris Miller, were announced as producers. The film, The Lego Ninjago Movie, was released in September 2017. A computer-generated animated series based on Lego Ninjago: Masters of Spinjitzu began in 2011, and another based on Legends of Chima began in 2013. A television series of Lego City has also been announced.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
With a price tag of £69.99/$79.99 and a piece count of 807 it means you’re paying roughly 8-9p/9-10cents per piece, which isn’t too bad when you look at it that way. This set is also quite unique in that it contains the spoilerific Giant Man brick built figure. Also in the set is the airport control tower, a baggage car and a smaller version of the Quinjet.
In 2008, the entire runway was renovated and paved, and a new taxiway was built, nicknamed "Mike". This major task only took 14 hours. The runway was closed over night between the hours 23:00 and 06:00. This did not prevent a Boeing 737-800 from Ryanair landing at one end of the runway, while they worked at the other end. The same year was also a record year for the airport. 2,546,856 passengers passed through the terminals, an increase of 12.7 percent compared with 2007.
A minifigure can comfortably fit seated inside the cockpit, and it is here that I found the first issue with the set. I had no issue inserting and removing the figure from his seated position, but my seven-year old struggled to get him out, deciding to leave him onboard instead of disembarking after she brought the jet back into the hangar. The physical connection between LEGO pieces in the cockpit and the pilot minifigure didn’t seem to present an issue, so whether or not this was just a one-off issue remains to be seen.
The two stunt jets included here actually have some similarity in the basic design and colour scheme to the main piece seen in the Marvel Super Heroes Avenjet Space Mission set. With that being said, I loved the Avenjet in that particular set, so any similarity holds no issue with me. The red and white colours work really well together, and it looks like something you would genuinely see flying through the sky at an air show. I really love it when LEGO truly capture the essence of what you are building, and they do that here. The jets themselves, as I said before, are similar to previously-released jets, and therefore the builds won’t come as any main surprise. That shouldn’t detract from the product, however, as it is a prime example of LEGO finding a winning formula and not really needing to change it.
Frequently Asked Questions | About Brickset | Privacy and Cookies | Affiliate Marketing Disclosure | Site Map | Contact Us LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2018 The LEGO Group. Brickset, the Brickset logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©1997-2018 Brickset ltd.