It’s always tough to sum up a set that has the sort of price tag that this one carries; because it doesn’t necessarily offer the collectors value that a Marvel or Star Wars set will offer, it can be a little harder to justify an outlay on, in this case, a few planes and a aircraft hangar. However, if you have a love for the City range, whether it be a nostalgic look back at your childhood, the general consistently-superior design of the range, or simply because your kids want an airport to build, this one has to be recommended. Once I finished building this, I set it up in my daughter’s bedroom, and the overjoyed expression on her face, followed by the extended time taken to play with the planes and flying them all over her room, made every single minute of the build worthwhile. Watching her swirl around her room – and later, the rest of house – clutching the planes and bringing them in for landings into the hangar, reminded me of why I fell in love with LEGO in the the first place; imagination.
Basically, the only thing that the two sets have in common is that they both have planes. However there is quite a bit of difference on the inside of the planes. There are a lot more details in the Friends plane. In addition to the seats, there is a rolling service cart complete with refreshments, emergency lighting as well as a larger galley and lav in the back of the plane.
The main constituents of the set are a tanker truck, three aircraft and a hangar. Each of these gets its own instruction booklet and bags of elements. First up is the tanker truck (below) which at only four studs wide and less than ten studs in length reminds me of the 4-stud wide vehicles of my youth. This impression is reinforced by the inclusion of a couple of late 70’s-style 2 x 4 mudguards in the build.
This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
I did prefer the previous 3182 airport set as it had a lot more components. But, I realise that it makes more business sense to offer a little less than raise the price of an already expensive product. However, 60104 is still a nice set and is often very well discounted in the UK so, I ordered a pallet load from Tesco during their 3-for-2 which made them a half-priced no-brainer ;-)
This was bought for my son's 5th birthday. If your kid likes to really play with the sets like mine does (not just bought for building it) be aware that the door of the airplane likes to pop off if it is not opened/closed just the right way with gentle hands. My son is a typical rambunctious boy and is not great at opening/closing things gingerly, so the door presents a bit of a problem for him. He doesn't have the dexterity or patience to snap the two tiny joint pieces onto the little pole just so yet, so whenever the door comes off he gets frustrated and needs help. Which is fine, we help him and he will eventually learn to do it himself, but just wanted to make y'all aware of this in case you have someone who is picky about the door opening and closing easily/correctly :) I know some little ones get fussy about these things!
Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.
In 2008, the entire runway was renovated and paved, and a new taxiway was built, nicknamed "Mike". This major task only took 14 hours. The runway was closed over night between the hours 23:00 and 06:00. This did not prevent a Boeing 737-800 from Ryanair landing at one end of the runway, while they worked at the other end. The same year was also a record year for the airport. 2,546,856 passengers passed through the terminals, an increase of 12.7 percent compared with 2007.
Lego Games launched in 2009, was a series of Lego-themed board games designed by Cephas Howard and Reiner Knizia in which the players usually build the playing board out of Lego bricks and then play with Lego-style players. Examples of the games include "Minotaurus", in which players roll dice to move characters within a brick-build labyrinth, "Creationary", in which players must build something which appears on a card, or "Ramses Pyramid", in which players collect gems and climb up a customisable pyramid. Like many board games, the games use dice. In Lego Games, the dice are Lego, with Lego squares with symbols on Lego studs on the dice, surrounded by rubber. The games vary from simple to complex, some are similar to "traditional" board games, while others are completely different.
Young builders and adventurers will love conquering a construction challenge and then taking a trip with LEGO City Airlines. This set features an airport terminal facade with control tower, luggage conveyor belt, revolving doors, and security check. The passenger airplane has a door that opens, a galley, and a lavatory, and there is also a luggage trailer, a fuel trailer, a mobile stairway, and an airport service car. Great for inspiring imaginative play, this impressive set can be combined with others in the LEGO City Airport collection for endless role play and configuration options.
From mid-2009, the airport was served by 9 airlines flying regular flight service, of which KLM had the busiest route with over 200,000 annual passengers to Amsterdam Schiphol. In 2011, Ryanair announced that Billund Airport with effect from 25 March 2012 would be the base for two Boeing 737 aircraft. At the same time Ryanair published 5 new routes, so that, from the summer of 2012, they would fly to 19 destinations.
The Lego Group began in the workshop of Ole Kirk Christiansen (1891–1958), a carpenter from Billund, Denmark, who began making wooden toys in 1932. In 1934, his company came to be called "Lego", derived from the Danish phrase leg godt, which means "play well". In 1947, Lego expanded to begin producing plastic toys. In 1949 Lego began producing, among other new products, an early version of the now familiar interlocking bricks, calling them "Automatic Binding Bricks". These bricks were based on the Kiddicraft Self-Locking Bricks, which had been patented in the United Kingdom in 1939 and released in 1947. Lego had received a sample of the Kiddicraft bricks from the supplier of an injection-molding machine that it purchased. The bricks, originally manufactured from cellulose acetate, were a development of the traditional stackable wooden blocks of the time.
By 1954, Christiansen's son, Godtfred, had become the junior managing director of the Lego Group. It was his conversation with an overseas buyer that led to the idea of a toy system. Godtfred saw the immense potential in Lego bricks to become a system for creative play, but the bricks still had some problems from a technical standpoint: their locking ability was limited and they were not versatile. In 1958, the modern brick design was developed; it took five years to find the right material for it, ABS (acrylonitrile butadiene styrene) polymer. The modern Lego brick design was patented on 28 January 1958.
Since 1963, Lego pieces have been manufactured from a strong, resilient plastic known as acrylonitrile butadiene styrene (ABS). As of September 2008, Lego engineers use the NX CAD/CAM/CAE PLM software suite to model the elements. The software allows the parts to be optimised by way of mould flow and stress analysis. Prototype moulds are sometimes built before the design is committed to mass production. The ABS plastic is heated to 232 °C (450 °F) until it reaches a dough-like consistency. It is then injected into the moulds at pressures between 25 and 150 tonnes, and takes approximately 15 seconds to cool. The moulds are permitted a tolerance of up to twenty micrometres, to ensure the bricks remain connected. Human inspectors check the output of the moulds, to eliminate significant variations in colour or thickness. According to the Lego Group, about eighteen bricks out of every million fail to meet the standard required. Lego factories recycle all but about 1 percent of their plastic waste from the manufacturing process. If the plastic cannot be re-used in Lego bricks, it is processed and sold on to industries that can make use of it. Lego has a self-imposed 2030 deadline to find a more eco-friendly alternative to the ABS plastic it currently uses in its bricks.