Last to be assembled is the hangar, which given its size is a surprisingly quick build – even though I’m a notoriously slow builder it took me barely ten minutes to put it together. The first step involves stacking dark bluish grey and orange plates and tiles to create a three-sided enclosure covering an area of 24 x 32 studs. Two side walls are then constructed from 1 x 6 x 5 rectangular girders topped off with dark bluish grey bricks and orange tiles, after which the roof is assembled, predominantly from a few large plates including a black 8 x 16 plate only previously available in two sets, and four dark bluish grey 6 x 24 plates which are only appearing in a set for the second time ever. A couple of stickers at the front of the structure identify it as an Airshow Hanger; to be frank, describing it as a hanger is probably exaggerating the case a bit as with its open front and rear it’s more akin to a large shelter.
@josekalel: I think the size of the terminal is kept in check for price reasons more than anything. This is a $100 set, and while bigger and pricier City sets exist, they tend to be few in number. What's more, the disadvantage to having a plane wide enough to seat two rows of passengers is that it inevitably takes up a big portion of the budget even for a larger set like this one. If the set were just the airport with no plane, then the terminal could probably be around twice this size at the very least… but then the set would not offer such a complete play experience.
The main wings are made up of a pair of white 10 x 10 wedge plates with cut corner and no studs in the centre; these are rare, having only previously appeared in two sets in this colour. The red 1 x 1 plate with tooth on each wing tip is also uncommon, having appeared in less than ten sets to date. The sides of the cockpit are made up of stickered red 1 x 4 x 1 panels, and it definitely helps if you concentrate when you apply the stickers, which I clearly didn’t as you can see in the picture below…. The area behind the cockpit canopy is nicely contoured by a red 4 x 4 triple wedge which, I was surprised to discover, has only previously appeared in a single set in this colour. Not to be outdone, however, the large 12 x 2 x 5 tail is appearing for the very first time in red. The hinged trans-black cockpit canopy is yet another rare element, appearing here for only the second time ever; rare it might be, but its pronounced curvature unfortunately means that it somewhat spoils the hitherto sleek lines of the jet. The flipside of this, however, is that the cockpit can comfortably accommodate the pilot.
I would also have liked a proper Ant-Man minifig – we get a micro Ant-Man, Giant-Man but not a regular-sized Ant-Man. There is a minifigure-sized Scott Lang hole in this set, and I think LEGO have wasted a great opportunity inserting a really popular and coveted minifigure into their flagship Civil War set. I would even gladly trade Cap and Bucky for one Ant-Man minifig.
Bag 7 finished off the front facade adds in a metal detector and the baggage check-in station.  I guess you enter from the right and then maybe the revolving doors are where you can walk out to the plane.  I'm not really sure anymore.  The conveyor belt is a nice addition to the set for playability and is set up so you can pull the baggage cart right next to it.  
Next we have the two Jet Pilots, one female and one male, both of which have identical torsos and helmets. The dark blue torsos, which are unique to this set, are printed with a nice design featuring a red jet with a red, white and gold jet wake plus gold jet insignia on the left breast. The white helmets incorporate a trans-black visor which can be raised and lowered; the helmets feature a print consisting of a star flanked with gold stripes, and like the torsos they’re currently exclusive to this set.
Frequently Asked Questions | About Brickset | Privacy and Cookies | Affiliate Marketing Disclosure | Site Map | Contact Us LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2018 The LEGO Group. Brickset, the Brickset logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©1997-2018 Brickset ltd.
Every good airport needs a hangar for the planes, and this is no exception. The satisfactory hangar included here does come across as rather basic, and while it doesn’t detract from the overall package, it isn’t going to swing your decision over whether to purchase this (and truthfully, I think you would have already made that decision before you come to the hangar). The design itself is simple, with the build unlikely to take you more than 10 minutes. That being said, it is a well-built piece and doesn’t feel flimsy, which was the impression I had when I first saw a picture of it. The criss-cross pieces towards the base give it a firm foundation, and there are plenty of long pieces which add further stability to it. Plane-wise, it is best suited for the old-fashioned vehicle, with the orange colouring in the design going well with the plane. Only a couple of stickers in use here, with just the AIRSHOW HANGAR words needing to be added.
I like the nod to the classic LEGO Ideas Book with the 'Follow Me' sticker, but overall I think the F-18 type jet is redundant, making the whole thing over-priced. Had it been presented in a different colour scheme from the Viggen, and maybe a bit of a sleeker or more agile design in itself, it might have been a worthwhile inclusion. But as it is, it just superficially looks like two fairly similar aircraft, and thus quite a bit less value for money as a set.
The body of the plane is built with five seats for passengers. The wings are added next with what I think are filler stickers added to the top of the wings. There is a small galley with sink and oven in the front of the plane right behind the cockpit. The cockpit uses only one sticker to show navigation equipment - the other is printed, which is always welcome (though not a new piece). A lavatory is installed in the back, and then the inside is complete. There is an odd choice for the door to the lav - a swinging door. Not much opportunity for privacy!
I purchased this set the day it was released for my LEGO City, as an upgrade from my previous airport (10159 Airport from 2004). First off, the build is great and although it's not very challenging, it's exciting to see the plane come to life and the use of the big plane pieces (eg. the nose, the wings, the tail etc.) was new to me, though I know there have been a number of planes in the past that use these pieces. There are 4 instruction booklets (2 for the plane, one for the airport, and one for the luggage/fuel/stairs car), 8 numbered bags, and two separate bags with the bigger pieces in. This makes the build very easy to follow. The completed set is very grand (especially the plane) in scale, and great looking. It's nice to see that a different colour scheme been used for the plane as opposed to the usual red and white or blue and white colours as seen in previous sets. The plane is HUGE, with a wingspan of around 2 32-wide baseplates (bare this in mind if you want to make a runway). However, despite its huge size, the inside of the plane is very bare. There are 5 seats for the passengers, another one facing backwards which I presume is for the cabin crew (although there isn't a cabin crew minifigure, which would have been a nice addition), and two seats in the cockpit. There's a tiny bathroom at the back of the plane, and a small galley area at the front with a sink and cupboard. There's easily room for a sixth chair in the plane, which I think should have been included, and the space within the plane could've been arranged better to fully optimise the area. The airport terminal has a very nice modern look, and includes the revolving door, tower, waiting area, security scanner and check in desk with luggage conveyor. Although this sounds like a lot of features, the inside of the terminal is, again, very bare and the space could've been used better. There are only 4 seats in the waiting area, and a lot of the space is taken up by the revolving door. The operational conveyor belt for the luggage is a nice touch, though, and there is a fair bit of playability within. The service car is a nice addition to this set and gives it more playability. All the trailers (fuel, stairs and luggage) connect together and attach to the service car, which has a really cool "follow me" sign on the back. This is a really nice addition to the set. Overall, I really like this set because of how it looks and because there's plenty of opportunity for play, but I think a lot more thought could've gone into maximising the space within the plane and the airport. Some more minifigures would have been good, such as a member of the cabin crew, a check-in clerk and a security officer. The value for money is okay with this set, as you do get a lot of big pieces, but the bare interiors are a little disappointing for the price you pay.
By 1954, Christiansen's son, Godtfred, had become the junior managing director of the Lego Group.[13] It was his conversation with an overseas buyer that led to the idea of a toy system. Godtfred saw the immense potential in Lego bricks to become a system for creative play, but the bricks still had some problems from a technical standpoint: their locking ability was limited and they were not versatile.[3] In 1958, the modern brick design was developed; it took five years to find the right material for it, ABS (acrylonitrile butadiene styrene) polymer.[11][12] The modern Lego brick design was patented on 28 January 1958.[15]

I'm not sure what to make of the set yet. I like the planes (although that biplane really doesn't need the bubble canopy). The idea of adding a hangar is interesting and I don't mind that it's a bit open. But the fact that it'll only house one of the three planes is annoying. Having said that, I'm not sure what you could do about it. Tripling the hangar would make it big and boring and push the price up. Could they have done two planes and a double hangar?
×