Frequently Asked Questions | About Brickset | Privacy and Cookies | Affiliate Marketing Disclosure | Site Map | Contact Us LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2018 The LEGO Group. Brickset, the Brickset logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©1997-2018 Brickset ltd.
The Lego Movie, a feature film based on Lego toys, was released by Warner Bros. in February 2014.[81] It featured Chris Pratt in the lead role, with substantial supporting characters voiced by Will Arnett, Morgan Freeman, Liam Neeson, Alison Brie, Will Ferrell and Nick Offerman.[82] A contest was held for contestants to submit designs for vehicles to be used in the film.[83] After the release of The Lego Movie, independent Canadian toy retailers reported issues with shortages of Lego products and cited cancellations of Lego pre-orders without warning[84] as a motive to stock compatible, rival products.[85]
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
The differences between the two jets mainly come on the top and rear of the builds. One has a larger single rear fin and two larger wings at the back, while the other has two smaller fins and the large wings positioned in the middle of the vehicle. The nose and cockpit areas are identical on both jets, and both come with stickers; the airshow logo on the wings, and a plane motif on the sides.
This set has essentially all that's needed for airplane-related play: the plane, an airport terminal, and a service vehicle. And each part of the set is quite detailed. The plane feature a galley and a toilet; the service vehicle has stairs, a baggage trailer, etc; and the terminal has revolving doors, security check, and a baggage conveyor belt. The building process is also well planned out and documented. The child is eased into building by starting out with the service vehicle, then comes the plane, and last the terminal, which can be challenging.

Lego (Danish: [ˈleːɡo];[1][2] stylised as LEGO) is a line of plastic construction toys that are manufactured by The Lego Group, a privately held company based in Billund, Denmark. The company's flagship product, Lego, consists of colourful interlocking plastic bricks accompanying an array of gears, figurines called minifigures, and various other parts. Lego pieces can be assembled and connected in many ways to construct objects including vehicles, buildings, and working robots. Anything constructed can then be taken apart again, and the pieces used to make other objects.[3][4]
There are several robotics competitions which use the Lego robotics sets. The earliest is Botball, a national U.S. middle- and high-school competition stemming from the MIT 6.270 Lego robotics tournament. Other Lego robotics competitions include Junior FIRST LEGO League (Jr.FLL) for students ages 6–9 and FIRST Lego League (FLL) for students ages 9–16 (age 9–14 in the United States, Canada, and Mexico). Jr.FLL and FLL offer real-world engineering challenges to participants. FLL uses Lego-based robots to complete tasks. Jr.FLL participants build models out of Lego elements. In its 2010 season, there were 16,070 FLL teams in over 55 countries. In its 2010 season, there were 2,147 Jr.FLL teams with 12,882 total student participants in the United States and Canada. The international RoboCup Junior football competition involves extensive use of Lego Mindstorms equipment which is often pushed to its extreme limits.[53]
Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.

The cockpit, including the stickers on the sides and the canopy, is identical to that of the first jet, as is the front of the aircraft. As previously noted, however, the wing configuration is different, as is the tail design which features twin tail fins and a pair of fuselage-mounted tailplanes. The red 4 x 1 x 3 tail fins, which have appeared in a total of seven sets including this one, are angled outwards similar to the arrangement on an F/A-18 Hornet. Overall, it’s another sleek design but once again the smooth lines are somewhat spoiled by the prominent canopy.
In December 2012, the BBC's More or Less radio program asked the Open University's engineering department to determine "how many Lego bricks, stacked one on top of the other, it would take for the weight to destroy the bottom brick?"[44] Using a hydraulic testing machine, the engineering department determined the average maximum force a 2×2 Lego brick can stand is 4,240 newtons; since an average 2×2 Lego brick has a mass of 1.152 grams (0.0406 oz), according to their calculations it would take a stack of 375,000 bricks to cause the bottom brick to collapse, which represents a stack 3,591 metres (11,781 ft) in height.[44]

This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.