@josekalel: I think the size of the terminal is kept in check for price reasons more than anything. This is a $100 set, and while bigger and pricier City sets exist, they tend to be few in number. What's more, the disadvantage to having a plane wide enough to seat two rows of passengers is that it inevitably takes up a big portion of the budget even for a larger set like this one. If the set were just the airport with no plane, then the terminal could probably be around twice this size at the very least… but then the set would not offer such a complete play experience.
I did prefer the previous 3182 airport set as it had a lot more components. But, I realise that it makes more business sense to offer a little less than raise the price of an already expensive product. However, 60104 is still a nice set and is often very well discounted in the UK so, I ordered a pallet load from Tesco during their 3-for-2 which made them a half-priced no-brainer ;-)

The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
It’s always tough to sum up a set that has the sort of price tag that this one carries; because it doesn’t necessarily offer the collectors value that a Marvel or Star Wars set will offer, it can be a little harder to justify an outlay on, in this case, a few planes and a aircraft hangar. However, if you have a love for the City range, whether it be a nostalgic look back at your childhood, the general consistently-superior design of the range, or simply because your kids want an airport to build, this one has to be recommended. Once I finished building this, I set it up in my daughter’s bedroom, and the overjoyed expression on her face, followed by the extended time taken to play with the planes and flying them all over her room, made every single minute of the build worthwhile. Watching her swirl around her room – and later, the rest of house – clutching the planes and bringing them in for landings into the hangar, reminded me of why I fell in love with LEGO in the the first place; imagination.
There are 3 cardboard boxes with more Easter eggs. We get a few references to Marvel organisations such as A.I.M., who you may remember from Iron Man 3 as an R&D agency run by Aldrich Killian, Hammer, one of Stark Industries primary rivals which made an appearance in Iron Man 2, bankrolling Whiplash and finally a box with the Stark Industries logo on it.
Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.
Although no longer being published in the United States by Scholastic, books covering events in the Bionicle storyline are written by Greg Farshtey. They are still being published in Europe by AMEET. Bionicle comics, also written by Farshtey, are compiled into graphic novels and were released by Papercutz. This series ended in 2009, after nine years.[91]
The Lego Movie, a feature film based on Lego toys, was released by Warner Bros. in February 2014.[81] It featured Chris Pratt in the lead role, with substantial supporting characters voiced by Will Arnett, Morgan Freeman, Liam Neeson, Alison Brie, Will Ferrell and Nick Offerman.[82] A contest was held for contestants to submit designs for vehicles to be used in the film.[83] After the release of The Lego Movie, independent Canadian toy retailers reported issues with shortages of Lego products and cited cancellations of Lego pre-orders without warning[84] as a motive to stock compatible, rival products.[85]
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.