Other than the planes, I do find it unfortunate that the Friends set focuses on shopping and food like so many Friends sets, and I also think it is unfortunate that the City terminal only has the basics of the airport structure in the control tower and service truck. Having a control tower for the Friends set would have been great. Having a gift shop/cafe for the City terminal would have been a worthwhile addition and not something we have seen in many City sets.
Thanks for the great review and comparison. I've thought about getting the Friends Airport for my daughter, as we both like the amount of detail inside the plane. Why would Lego think that boys don't care as much about detail? I love the wider body planes, but it's a shame they're not producing the runway plates, or including them in the airport sets, anymore. I agree with ZeeBricks that if they're not going to include everything an airport needs (although as expensive as price/piece these sets are getting it would cost a fortune) they should sell smaller sets that can be added together. Now that I'm feeling nostalgic for classic airport I might rebuild my 6392 and dust off my 6396 and set them up tonight, it's time for some serious swooshing :)
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.