Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.
The set has an impressive assortment of minifigures - I quite like that it has six, allowing for a lot of play opportunities. All the major parts of the plane - the wing, cockpit, tail and body - are new to this set in their colours. The inside of the plane has a minimal amount of details, with five seats, a galley and a lavatory. The outside of the plane looks quite smart with all the stickers applied.
I'm not sure what to make of the set yet. I like the planes (although that biplane really doesn't need the bubble canopy). The idea of adding a hangar is interesting and I don't mind that it's a bit open. But the fact that it'll only house one of the three planes is annoying. Having said that, I'm not sure what you could do about it. Tripling the hangar would make it big and boring and push the price up. Could they have done two planes and a double hangar?
The main wings are made up of a pair of white 10 x 10 wedge plates with cut corner and no studs in the centre; these are rare, having only previously appeared in two sets in this colour. The red 1 x 1 plate with tooth on each wing tip is also uncommon, having appeared in less than ten sets to date. The sides of the cockpit are made up of stickered red 1 x 4 x 1 panels, and it definitely helps if you concentrate when you apply the stickers, which I clearly didn’t as you can see in the picture below…. The area behind the cockpit canopy is nicely contoured by a red 4 x 4 triple wedge which, I was surprised to discover, has only previously appeared in a single set in this colour. Not to be outdone, however, the large 12 x 2 x 5 tail is appearing for the very first time in red. The hinged trans-black cockpit canopy is yet another rare element, appearing here for only the second time ever; rare it might be, but its pronounced curvature unfortunately means that it somewhat spoils the hitherto sleek lines of the jet. The flipside of this, however, is that the cockpit can comfortably accommodate the pilot.
The final two minifigures are the Biplane Pilot and the intrepid Wing Walker. Both of these minifigures share the same white torso which is printed with a flight suit design overlaid with dark red and bright light orange flames plus a logo over the left breast. The torso design is superb and it can at present only be found in this set. Both minifigures are provided with a reddish brown aviator cap and dark bluish grey goggles, and the pilot (below left) also gets an alternative to this headgear in the form of medium dark flesh mid-length hair which has only ever appeared in five sets in this colour.
×