Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
Bag 4 finishes the fuselage and all that is left are the engines and tail section. You'll notice that this aircraft has a bathroom on board as well as some storage for a non-existent flight attendant. I think this is the first time that LEGO has put some additional details into aircraft besides just seats. Also there is only one pilot for a 2 seat cockpit in the set.
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
Will agree with some other reviewers that some parts will fall off with normal-rough play. However, the attention to detail is pretty cool and almost makes up for it. The top is hard to take off and put on to move the minifigs. There is a TSA checkpoint, a conveyor belt for luggage, a rather impressive runway vehicle. Couple this with the cargo plane or another airplane set and some atraight road nameplates, you got an airport without spending a fortune.
City is the thematic title under which most Town-related System sets were released from 2005 and onward. There are numerous sets that are associated with Construction, Police, Fire, Emergency, Train, Airport, Transportation, Cargo, Traffic, Coast Guard, Farm, Great Vehicles, Mining, and Space. European catalogs featured another theme called City in the years 1999 to 2000, which was referred to as City Center in American catalogs.
The Lego Group began in the workshop of Ole Kirk Christiansen (1891–1958), a carpenter from Billund, Denmark, who began making wooden toys in 1932. In 1934, his company came to be called "Lego", derived from the Danish phrase leg godt, which means "play well". In 1947, Lego expanded to begin producing plastic toys. In 1949 Lego began producing, among other new products, an early version of the now familiar interlocking bricks, calling them "Automatic Binding Bricks". These bricks were based on the Kiddicraft Self-Locking Bricks, which had been patented in the United Kingdom in 1939 and released in 1947. Lego had received a sample of the Kiddicraft bricks from the supplier of an injection-molding machine that it purchased. The bricks, originally manufactured from cellulose acetate, were a development of the traditional stackable wooden blocks of the time.
^ Jump up to: a b Alexander, Ruth (3 December 2012). "How tall can a Lego tower get?". BBC News. Archived from the original on 4 December 2012. Retrieved 4 December 2012. The average maximum force the bricks can stand is 4,240N. That's equivalent to a mass of 432 kg (950lbs). If you divide that by the mass of a single brick, which is 1.152g, then you get the grand total of bricks a single piece of Lego could support: 375,000. So, 375,000 bricks towering 3.5 kilometers (2.17 miles) high is what it would take to break a Lego brick.
The set contains six minifigures. Even though they all incorporate standard, unprinted minifigure legs together with commonly-available headprints, it appears that all six are unique to the set. First up are two members of the Ground Crew (below). The bearded guy has an orange torso printed with a hi-viz jacket, ID badge and red pen pattern. This has appeared in nine sets to date including all of the 2016 Airport sets plus 60080 Spaceport which I reviewed here last summer. His red construction helmet, which incorporates a pair of non-removable black ear muffs, has appeared in less than ten sets to date. The other member of the ground crew has a rather nice printed medium blue torso which is new this year and has only appeared in a total of three sets including this one. It features a shirt print which includes the Octan logo and a top pocket complete with a pen.
Agent 13 has a pretty plain appearance, with caramel-coloured wavy hair, and a black, spy-like top. Her torso has some nice details, with sharp, angular lines that all combine to form a rough outline of an upside down star. She has plain sand blue pants and rocks a sub-machine gun accessory. I like regular LEGO firearms, so it’s very nice to get one in this set as they’re fairly uncommon.
If you don’t own Black Panther Pursuit or any of the sets that included Captain America, I guess it would a plus getting the both of them in this set but Super Heroes collectors tend to be completionists, so I think that scenario will be particularly rare. I guess you could always sell your spares on the secondary market, but really, who wants to do that?
This is a good set if you want an airport. The set includes a big plain and a terminal. The terminal has a control tower, check-in, luggage handler, fuel tank, ... I expanded my terminal and built it on a 32x32 baseplate and used the 2 grey 16x16 plates for the roof. The backside is not completely closed. Otherwise is the luggage belt is not accessible with my hand. I added 2 extra seats in the plane. Normally you have 6 seats in the plane, but I raised it to 8. I wanted more than 8 but that is almost not possible. The plane is brought with a big brick which includes the middle of the plane and the 2 wings and that one limits the possibilities. The toilet in the plane is still on the backside.
The final two minifigures are the Biplane Pilot and the intrepid Wing Walker. Both of these minifigures share the same white torso which is printed with a flight suit design overlaid with dark red and bright light orange flames plus a logo over the left breast. The torso design is superb and it can at present only be found in this set. Both minifigures are provided with a reddish brown aviator cap and dark bluish grey goggles, and the pilot (below left) also gets an alternative to this headgear in the form of medium dark flesh mid-length hair which has only ever appeared in five sets in this colour.