The upper and lower wings are connected by a dark bluish grey 4 x 1 x 3 tail on either side; this tail element is unique to the set in this colour, although has previously appeared in a couple of sets back in 2003 in old dark grey. The upper wing is also supported by a couple of 1 x 2 x 2 black windows placed back to back in front of the cockpit, which from the perspective of the pilot really can’t be good for visibility. The biplane has a three blade propeller and the tips of the blades are stickered prior to sliding the propeller on to a 6L axle protruding from the front of the fuselage where it’s held in place by an orange 2 x 2 brick with domed top. The last step is to attach a 1 x 4 x 2 bar to the top of the upper wing for the Wing Walker to hold on to and then we’re done with the biplane.
Copenhagen is not only the main airport for the densely-populated Øresund region, but also the main air transportation hub for Scandinavia, the main hub for the joint Danish-Swedish-Norwegian carrier SAS Group, and one of Europe's major hubs. There is a large number of intercontinental connections to Copenhagen, as well as a dense network of short-haul connections from Copenhagen to destinations throughout all of Europe, especially the Nordic countries.
Parking capacity at Copenhagen Airport was greatly expanded in 2015 with the construction of a new lot as one of the first phases in an ambitious airport expansion plan scheduled to roll out in the coming decades. There are several lots: those near the terminals are very expensive, while the further-flung ones are cheaper (but have free shuttle bus service to the terminals).
Since 1963, Lego pieces have been manufactured from a strong, resilient plastic known as acrylonitrile butadiene styrene (ABS). As of September 2008, Lego engineers use the NX CAD/CAM/CAE PLM software suite to model the elements. The software allows the parts to be optimised by way of mould flow and stress analysis. Prototype moulds are sometimes built before the design is committed to mass production. The ABS plastic is heated to 232 °C (450 °F) until it reaches a dough-like consistency. It is then injected into the moulds at pressures between 25 and 150 tonnes, and takes approximately 15 seconds to cool. The moulds are permitted a tolerance of up to twenty micrometres, to ensure the bricks remain connected. Human inspectors check the output of the moulds, to eliminate significant variations in colour or thickness. According to the Lego Group, about eighteen bricks out of every million fail to meet the standard required. Lego factories recycle all but about 1 percent of their plastic waste from the manufacturing process. If the plastic cannot be re-used in Lego bricks, it is processed and sold on to industries that can make use of it. Lego has a self-imposed 2030 deadline to find a more eco-friendly alternative to the ABS plastic it currently uses in its bricks.
Domain Administrator of LEGO Juris A/S failed to keep it trustworthy. Please be warned that to describe security status of Lego-airport.com we use data openly available on the Web, thus we cannot guarantee that no scam sites might have been mistakenly considered legit and no fraud or PC issues may occur in this regard. But usually the crowdsourced data we have is pretty accurate. Let's see it below.
The main constituents of the set are a tanker truck, three aircraft and a hangar. Each of these gets its own instruction booklet and bags of elements. First up is the tanker truck (below) which at only four studs wide and less than ten studs in length reminds me of the 4-stud wide vehicles of my youth. This impression is reinforced by the inclusion of a couple of late 70’s-style 2 x 4 mudguards in the build.
With a price tag of £69.99/$79.99 and a piece count of 807 it means you’re paying roughly 8-9p/9-10cents per piece, which isn’t too bad when you look at it that way. This set is also quite unique in that it contains the spoilerific Giant Man brick built figure. Also in the set is the airport control tower, a baggage car and a smaller version of the Quinjet.
This brings us to the main reason most people will get this set. The Giant Man figure. What a revelation. Lego could’ve simply released him as one of their larger scale figs like The Hulk or Thanos. Instead they’ve really outdone themselves and designed a brick built figure that looks like a regular minifig grew really big. Huzzah! There are quite a few stickers to apply, but it’s so fun to build him and put him next to the others. On the negative, they could’ve done something to spruce up his back. From the front he’s almost perfect but you turn him around and you just see the bottom of his constituent parts. It’s a minor negative on an otherwise impressive feature, however.
So that's it... It's the first passenger airport set released in 6 years. It comes with a jet, 6 minifigures, a terminal, and some equipment for servicing the aircraft. Should you get it? After getting it, I'm glad I got it on sale, but I'm still not sure it was worth what I paid. I think it needs at least another terminal worker and then a pilot and flight attendant. Also you're paying for a lot of BURPs to help smooth the aircraft out. The age range listed is 6-12 years old so clearly it is not meant for old farts like me looking for a good building experience. However, if you're a LEGO CITY fan and you build your own MOCs to go with your city, it has some good additions. If you're looking to build an airport terminal of your own, you'll find some useful parts to make it realistic. We'll see if it takes another 6 years for an upgrade.
Agent 13 has a pretty plain appearance, with caramel-coloured wavy hair, and a black, spy-like top. Her torso has some nice details, with sharp, angular lines that all combine to form a rough outline of an upside down star. She has plain sand blue pants and rocks a sub-machine gun accessory. I like regular LEGO firearms, so it’s very nice to get one in this set as they’re fairly uncommon.