@DrDave : My thoughts were not that the hangar should be big enough to hold *all* aircraft simultaneously - which would, indeed, make it huge! - but that it should at least be big enough to hold any one of them. Just a few studs wider should cover the wingspan of either jet (judging from the photos). Add a few centimetres to the height - by whatever construction means - and that'll accommodate the oversized tail on the Viggen-styled plane. If/when I pick up this set, that's the mods I'll be making to it.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
It’s always tough to sum up a set that has the sort of price tag that this one carries; because it doesn’t necessarily offer the collectors value that a Marvel or Star Wars set will offer, it can be a little harder to justify an outlay on, in this case, a few planes and a aircraft hangar. However, if you have a love for the City range, whether it be a nostalgic look back at your childhood, the general consistently-superior design of the range, or simply because your kids want an airport to build, this one has to be recommended. Once I finished building this, I set it up in my daughter’s bedroom, and the overjoyed expression on her face, followed by the extended time taken to play with the planes and flying them all over her room, made every single minute of the build worthwhile. Watching her swirl around her room – and later, the rest of house – clutching the planes and bringing them in for landings into the hangar, reminded me of why I fell in love with LEGO in the the first place; imagination.
Apart from that, both carriers have extensive networks within Europe and the Mediterranean (including North Africa and the Middle East). SAS flies to most European capitals, and has a particularly dense network of connections across the Baltic Sea, to Finland, Estonia, Latvia and Lithuania, as well as to Poland, where it serves the majority of even small airports. There is also a fairly good network of connections to the United Kingdom and, perhaps surprisingly, to Italy, where even smaller airports like Bologna are served.
Bag 6 starts the airport terminal. Like most CITY builds, they are meant for play so it's really only half a building. It includes one minifigure and the revolving door entrance. While the entrance is cool looking, it's about twice the height of a minifigure and there isn't enough physical space for one actually to fit through the door. I'm not a fan of the design.
Merlin Entertainments operates seven Legoland amusement parks, the original in Billund, Denmark, the second in Windsor, England, the third in Günzburg, Germany, the fourth in Carlsbad, California, the fifth in Winter Haven, Florida, the sixth in Nusajaya, Malaysia and the seventh in Dubai, United Arab Emirates. and the eighth in Shanghai, Peoples of Republic of China. On 13 July 2005, the control of 70% of the Legoland parks was sold for $460 million to the Blackstone Group of New York while the remaining 30% is still held by Lego Group. There are also eight Legoland Discovery Centres, two in Germany, four in the United States, one in Japan and one in the United Kingdom. Two Legoland Discovery Centres opened in 2013: one at the Westchester Ridge Hill shopping complex in Yonkers, NY and one at the Vaughan Mills in Vaughan, Ontario, Canada. Another has opened at the Meadowlands complex in East Rutherford, New Jersey in 2014.
The first few bags build the small truck with carts that you see on airport runways. The truck has a "follow me" sign that I confess I have not seen at any airport. There is also a fueling tank and a rolling staircase that sits next to the plane to allow for boarding. Both the tank and the staircase are additional carts for the truck, though I am guessing not both at the same time.
In 2008, the entire runway was renovated and paved, and a new taxiway was built, nicknamed "Mike". This major task only took 14 hours. The runway was closed over night between the hours 23:00 and 06:00. This did not prevent a Boeing 737-800 from Ryanair landing at one end of the runway, while they worked at the other end. The same year was also a record year for the airport. 2,546,856 passengers passed through the terminals, an increase of 12.7 percent compared with 2007.
I’m pleased to report that I thoroughly enjoyed building this set, and what’s more I quite enjoyed playing with it afterwards as well…. First and foremost it’s an excellent play set – it’s not often that you get three good-sized vehicles plus a large building and a number of accessories in a single set at this price point. Furthermore, all three aircraft are actually pretty good, particularly the two jets which look really sleek apart from their prominent cockpit canopies. The jets are also solidly built, surprisingly weighty, and eminently swooshable; you can conveniently grab them by their lateral air intakes and nothing falls off when you swoosh them around - I know this as I extensively tested this particular play feature…. The hanger is admittedly a bit insubstantial, but overall this set lived up to my expectations and I’ll certainly be picking up a couple more of the Airport sets this summer.
From mid-2009, the airport was served by 9 airlines flying regular flight service, of which KLM had the busiest route with over 200,000 annual passengers to Amsterdam Schiphol. In 2011, Ryanair announced that Billund Airport with effect from 25 March 2012 would be the base for two Boeing 737 aircraft. At the same time Ryanair published 5 new routes, so that, from the summer of 2012, they would fly to 19 destinations.
Other than the planes, I do find it unfortunate that the Friends set focuses on shopping and food like so many Friends sets, and I also think it is unfortunate that the City terminal only has the basics of the airport structure in the control tower and service truck. Having a control tower for the Friends set would have been great. Having a gift shop/cafe for the City terminal would have been a worthwhile addition and not something we have seen in many City sets.
By 1954, Christiansen's son, Godtfred, had become the junior managing director of the Lego Group. It was his conversation with an overseas buyer that led to the idea of a toy system. Godtfred saw the immense potential in Lego bricks to become a system for creative play, but the bricks still had some problems from a technical standpoint: their locking ability was limited and they were not versatile. In 1958, the modern brick design was developed; it took five years to find the right material for it, ABS (acrylonitrile butadiene styrene) polymer. The modern Lego brick design was patented on 28 January 1958.
Every good airport needs a hangar for the planes, and this is no exception. The satisfactory hangar included here does come across as rather basic, and while it doesn’t detract from the overall package, it isn’t going to swing your decision over whether to purchase this (and truthfully, I think you would have already made that decision before you come to the hangar). The design itself is simple, with the build unlikely to take you more than 10 minutes. That being said, it is a well-built piece and doesn’t feel flimsy, which was the impression I had when I first saw a picture of it. The criss-cross pieces towards the base give it a firm foundation, and there are plenty of long pieces which add further stability to it. Plane-wise, it is best suited for the old-fashioned vehicle, with the orange colouring in the design going well with the plane. Only a couple of stickers in use here, with just the AIRSHOW HANGAR words needing to be added.
Parking capacity at Copenhagen Airport was greatly expanded in 2015 with the construction of a new lot as one of the first phases in an ambitious airport expansion plan scheduled to roll out in the coming decades. There are several lots: those near the terminals are very expensive, while the further-flung ones are cheaper (but have free shuttle bus service to the terminals).
Lego also initiated a robotics line of toys called 'Mindstorms' in 1999, and has continued to expand and update this range ever since. The roots of the product originate from a programmable brick developed at the MIT Media Lab, and the name is taken from a paper by Seymour Papert, a computer scientist and educator who developed the educational theory of constructionism, and whose research was at times funded by the Lego Group.
I cannot stress just how much I love this item, it may well be the highlight of the whole set. LEGO have released bi-planes before of similar design, but it still something to marvel over. Harking back to those older days of LEGO relying on imagination and not movie franchises, this is what we had to play with, and it is great to be able to relive that in today’s world.
The rest of the model is pretty standard for a Marvel release. Most of the larger sets revolve around a vehicle and/or small structure. This one doesn’t disappoint in that respect. First up, you get the airport control tower. It’s fairly uninteresting, although they have added an exploding wall-play feature which kinda makes up for it. Otherwise, though, it’s simply a tower. In addition to that you get a small baggage car, which is pretty neat. In fairness, as cute as it is, it feels like an attempt to bump up the number of pieces. Lastly, the set comes with a Quinjet. This particular vehicle is considerably smaller than the previous two minifigure-scale Quinjets that Lego gave us last year and in 2012. That said, it’s a great model with some great features.
Even in terms of play value it mostly seems to be a trade-off — 60104 loses the vending machine, cafe, baggage x-ray scanner, and a few seats on the plane but gains a baggage conveyor, a restroom, a refueling tank for the plane, an additional minifigure, and more seats in the waiting area. It's pretty nice to see the value of a LEGO air terminal remain fairly stable even though the price has not increased.
Next we have the two Jet Pilots, one female and one male, both of which have identical torsos and helmets. The dark blue torsos, which are unique to this set, are printed with a nice design featuring a red jet with a red, white and gold jet wake plus gold jet insignia on the left breast. The white helmets incorporate a trans-black visor which can be raised and lowered; the helmets feature a print consisting of a star flanked with gold stripes, and like the torsos they’re currently exclusive to this set.
Compared to other major European hub airports, like Charles de Gaulle or Heathrow, CPH has a similar number of connections, but is much smaller in both actual size and passenger volumes, and can provide a calmer, more pleasant experience. Its location in the south of Scandinavia makes reaching most European destinations reasonable, and flying to destinations in the Baltic region and in Eastern Europe generally only takes half the time as from major hub airports in Western Europe.
The two stunt jets included here actually have some similarity in the basic design and colour scheme to the main piece seen in the Marvel Super Heroes Avenjet Space Mission set. With that being said, I loved the Avenjet in that particular set, so any similarity holds no issue with me. The red and white colours work really well together, and it looks like something you would genuinely see flying through the sky at an air show. I really love it when LEGO truly capture the essence of what you are building, and they do that here. The jets themselves, as I said before, are similar to previously-released jets, and therefore the builds won’t come as any main surprise. That shouldn’t detract from the product, however, as it is a prime example of LEGO finding a winning formula and not really needing to change it.
Since 1963, Lego pieces have been manufactured from a strong, resilient plastic known as acrylonitrile butadiene styrene (ABS). As of September 2008, Lego engineers use the NX CAD/CAM/CAE PLM software suite to model the elements. The software allows the parts to be optimised by way of mould flow and stress analysis. Prototype moulds are sometimes built before the design is committed to mass production. The ABS plastic is heated to 232 °C (450 °F) until it reaches a dough-like consistency. It is then injected into the moulds at pressures between 25 and 150 tonnes, and takes approximately 15 seconds to cool. The moulds are permitted a tolerance of up to twenty micrometres, to ensure the bricks remain connected. Human inspectors check the output of the moulds, to eliminate significant variations in colour or thickness. According to the Lego Group, about eighteen bricks out of every million fail to meet the standard required. Lego factories recycle all but about 1 percent of their plastic waste from the manufacturing process. If the plastic cannot be re-used in Lego bricks, it is processed and sold on to industries that can make use of it. Lego has a self-imposed 2030 deadline to find a more eco-friendly alternative to the ABS plastic it currently uses in its bricks.
Bag 3 starts the aircraft and includes 3 minifigures (2 passengers and a pilot) The aircraft has the standard wings and fuselage sections. I am not a fan of the giant wing piece as it limits the number of seats. It does however help to make the aircraft more realistic. Given the size of the aircraft, there are only 5 seats for passengers which is rather disappointing.
The set contains six minifigures. Even though they all incorporate standard, unprinted minifigure legs together with commonly-available headprints, it appears that all six are unique to the set. First up are two members of the Ground Crew (below). The bearded guy has an orange torso printed with a hi-viz jacket, ID badge and red pen pattern. This has appeared in nine sets to date including all of the 2016 Airport sets plus 60080 Spaceport which I reviewed here last summer. His red construction helmet, which incorporates a pair of non-removable black ear muffs, has appeared in less than ten sets to date. The other member of the ground crew has a rather nice printed medium blue torso which is new this year and has only appeared in a total of three sets including this one. It features a shirt print which includes the Octan logo and a top pocket complete with a pen.