If you don’t own Black Panther Pursuit or any of the sets that included Captain America, I guess it would a plus getting the both of them in this set but Super Heroes collectors tend to be completionists, so I think that scenario will be particularly rare. I guess you could always sell your spares on the secondary market, but really, who wants to do that?

The road distance is to Billund 3 kilometres (2 mi), to Vejle 28 kilometres (17 mi), to Kolding 41 kilometres (25 mi), to Esbjerg 61 kilometres (38 mi) and to Aarhus 98 kilometres (61 mi). There are airport buses to Horsens, Skanderborg and Aarhus. Eight additional bus services operate from the airport. There are six parking zones named after countries of the world, USA, Australia, Kenya, Spain, Egypt and Greenland. Three of the zones are connected by a shuttle bus, the other three being within walking distance.

The upper and lower wings are connected by a dark bluish grey 4 x 1 x 3 tail on either side; this tail element is unique to the set in this colour, although has previously appeared in a couple of sets back in 2003 in old dark grey. The upper wing is also supported by a couple of 1 x 2 x 2 black windows placed back to back in front of the cockpit, which from the perspective of the pilot really can’t be good for visibility. The biplane has a three blade propeller and the tips of the blades are stickered prior to sliding the propeller on to a 6L axle protruding from the front of the fuselage where it’s held in place by an orange 2 x 2 brick with domed top. The last step is to attach a 1 x 4 x 2 bar to the top of the upper wing for the Wing Walker to hold on to and then we’re done with the biplane.
Every good airport needs a hangar for the planes, and this is no exception. The satisfactory hangar included here does come across as rather basic, and while it doesn’t detract from the overall package, it isn’t going to swing your decision over whether to purchase this (and truthfully, I think you would have already made that decision before you come to the hangar). The design itself is simple, with the build unlikely to take you more than 10 minutes. That being said, it is a well-built piece and doesn’t feel flimsy, which was the impression I had when I first saw a picture of it. The criss-cross pieces towards the base give it a firm foundation, and there are plenty of long pieces which add further stability to it. Plane-wise, it is best suited for the old-fashioned vehicle, with the orange colouring in the design going well with the plane. Only a couple of stickers in use here, with just the AIRSHOW HANGAR words needing to be added.
A minifigure can comfortably fit seated inside the cockpit, and it is here that I found the first issue with the set. I had no issue inserting and removing the figure from his seated position, but my seven-year old struggled to get him out, deciding to leave him onboard instead of disembarking after she brought the jet back into the hangar. The physical connection between LEGO pieces in the cockpit and the pilot minifigure didn’t seem to present an issue, so whether or not this was just a one-off issue remains to be seen.

Yes, the famous franchises will remain the selling point for many a LEGO fan, but for those who spent years of their childhood sitting in their lounges or bedrooms building hospitals – nay, worlds – LEGO City is everything that you could need. And for a set such as this to bring back your childhood, as well as give you a thoroughly enjoyable build experience – and the added bonus of seeing a new generation of excited faces – this is a must-have set and worth every penny.
Thanks for the great review and comparison. I've thought about getting the Friends Airport for my daughter, as we both like the amount of detail inside the plane. Why would Lego think that boys don't care as much about detail? I love the wider body planes, but it's a shame they're not producing the runway plates, or including them in the airport sets, anymore. I agree with ZeeBricks that if they're not going to include everything an airport needs (although as expensive as price/piece these sets are getting it would cost a fortune) they should sell smaller sets that can be added together. Now that I'm feeling nostalgic for classic airport I might rebuild my 6392 and dust off my 6396 and set them up tonight, it's time for some serious swooshing :)
After World City's discontinuation in 2004, it was replaced with City as System's primary town-life related theme in 2005. However, unlike its predecessor, it was not limited to sets involving rescue services like Police, Fire or Coast Guard, but also introduced the first new construction site related sets since the discontinuation of City Center in 2000. In 2006, the first new airport set that included the first jetway since 6597 Century Skyway (1994) was released, as well as the first new hospital since 6380 Emergency Treatment Center from 1987. These releases expanded City to a scope only comparable to the original Town theme, and in 2009 it even went slightly beyond that, by introducing the first farm-related System sets. Also, in that year, City followed this route to release more truly civilian town life sets such as 7641 City Corner and 7639 Camper. In 2010 City released more civilian sets including 8403 Family House and 8404 Public Transport. In 2011 City re-introduced the Space sub-theme along with some new Harbour sets. In the first wave of 2012, City had forest police and fire sets as well as some more commercial/civilian sets. The second wave of 2012 featured the introduction of the Mining theme and respective sets, as well as a hospital. In the winter of 2013, Police and Fire sets were once again focused on but, contrary to those released in the previous year, were set in the city. In the summer of 2013, the Coast Guard and Cargo subthemes were brought back.

Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.

In December 2012, the BBC's More or Less radio program asked the Open University's engineering department to determine "how many Lego bricks, stacked one on top of the other, it would take for the weight to destroy the bottom brick?"[44] Using a hydraulic testing machine, the engineering department determined the average maximum force a 2×2 Lego brick can stand is 4,240 newtons; since an average 2×2 Lego brick has a mass of 1.152 grams (0.0406 oz), according to their calculations it would take a stack of 375,000 bricks to cause the bottom brick to collapse, which represents a stack 3,591 metres (11,781 ft) in height.[44]
The capabilities of the Mindstorms range have now been harnessed for use in Iko Creative Prosthetic System, a prosthetic limbs system designed for children. Designs for these Lego prosthetics allow everything from mechanical diggers to laser-firing spaceships to be screwed on to the end of a child's limb. Iko is the work of the Chicago-based Colombian designer Carlos Arturo Torres, and is a modular system that allows children to customise their own prosthetics with the ease of clicking together plastic bricks. Designed with Lego's Future Lab, the Danish toy company's experimental research department, and Cirec, a Colombian foundation for physical rehabilitation, the modular prosthetic incorporates myoelectric sensors that register the activity of the muscle in the stump and send a signal to control movement in the attachment. A processing unit in the body of the prosthetic contains an engine compatible with Lego Mindstorms, the company's robotics line, which lets the wearer build an extensive range of customised, programmable limbs.[54][55]

The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
Since 1963, Lego pieces have been manufactured from a strong, resilient plastic known as acrylonitrile butadiene styrene (ABS).[12][30] As of September 2008, Lego engineers use the NX CAD/CAM/CAE PLM software suite to model the elements. The software allows the parts to be optimised by way of mould flow and stress analysis. Prototype moulds are sometimes built before the design is committed to mass production. The ABS plastic is heated to 232 °C (450 °F) until it reaches a dough-like consistency. It is then injected into the moulds at pressures between 25 and 150 tonnes, and takes approximately 15 seconds to cool. The moulds are permitted a tolerance of up to twenty micrometres, to ensure the bricks remain connected.[33] Human inspectors check the output of the moulds, to eliminate significant variations in colour or thickness. According to the Lego Group, about eighteen bricks out of every million fail to meet the standard required.[37] Lego factories recycle all but about 1 percent of their plastic waste from the manufacturing process. If the plastic cannot be re-used in Lego bricks, it is processed and sold on to industries that can make use of it.[38][39] Lego has a self-imposed 2030 deadline to find a more eco-friendly alternative to the ABS plastic it currently uses in its bricks.[40]