Other than the planes, I do find it unfortunate that the Friends set focuses on shopping and food like so many Friends sets, and I also think it is unfortunate that the City terminal only has the basics of the airport structure in the control tower and service truck. Having a control tower for the Friends set would have been great. Having a gift shop/cafe for the City terminal would have been a worthwhile addition and not something we have seen in many City sets.
While I like their characters, I really don’t like LEGO recycling their characters. I can make an exception for Bucky, who until this year has only been made available as a pretty exclusive (and pricey) polybag but having this exact same Captain America show up in so many sets is pretty damn lazy. If a super hero minifig has been used a year ago, it really isn’t too much to ask for LEGO to update it slightly.
There are 3 cardboard boxes with more Easter eggs. We get a few references to Marvel organisations such as A.I.M., who you may remember from Iron Man 3 as an R&D agency run by Aldrich Killian, Hammer, one of Stark Industries primary rivals which made an appearance in Iron Man 2, bankrolling Whiplash and finally a box with the Stark Industries logo on it.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
Over the years, Lego has licensed themes from numerous cartoon and film franchises and even some from video games. These include Batman, Indiana Jones, Pirates of the Caribbean, Harry Potter, Star Wars, and Minecraft. Although some of the licensed themes, Lego Star Wars and Lego Indiana Jones, had highly successful sales, Lego has expressed a desire to rely more upon their own characters and classic themes, and less upon licensed themes related to movie releases.
Here’s a look at the Iron Man and War Machine minifigures. Tony Stark is rocking his Mark 46 Armour which should delight LEGO Iron Man collectors as it’s another cool variant. If you ask me, I can’t quite tell most of the suits apart, but I do appreciate that LEGO give us a fresh new Iron Man minifig with each movie-themed set. Both Iron Man and War Machine are exclusive to this set.
Manufacturing of Lego bricks occurs at several locations around the world. Moulding is done in Billund, Denmark; Nyíregyháza, Hungary; Monterrey, Mexico and most recently in Jiaxing, China. Brick decorations and packaging are done at plants in Denmark, Hungary, Mexico and Kladno in the Czech Republic. The Lego Group estimates that in five decades it has produced 400 billion Lego blocks. Annual production of Lego bricks averages approximately 36 billion, or about 1140 elements per second. According to an article in BusinessWeek in 2006, Lego could be considered the world's No. 1 tire manufacturer; the factory produces about 306 million small rubber tires a year. The claim was reiterated in 2012.
The Lego Movie, a feature film based on Lego toys, was released by Warner Bros. in February 2014. It featured Chris Pratt in the lead role, with substantial supporting characters voiced by Will Arnett, Morgan Freeman, Liam Neeson, Alison Brie, Will Ferrell and Nick Offerman. A contest was held for contestants to submit designs for vehicles to be used in the film. After the release of The Lego Movie, independent Canadian toy retailers reported issues with shortages of Lego products and cited cancellations of Lego pre-orders without warning as a motive to stock compatible, rival products.
Almost all major European carriers have a connection to Copenhagen from their main hubs. As Denmark holds sizable immigrant communities from various European countries, even smaller carriers have frequent connections to the likes of Sarajevo or Belgrade. Copenhagen Airport has been seeing increased traffic from low-fare carriers since the launch of the dedicated CPH Go section of the airport (with common check-in and security with other airlines, but separate gates and waiting area). Airlines using CPH Go include EasyJet, Ryanair, Transavia, and WizzAir, although the latter only for selected destinations, with the majority of its flights to the Øresund area landing at Malmö Sturup Airport instead.
Primary concept and development work takes place at the Billund headquarters, where the company employs approximately 120 designers. The company also has smaller design offices in the UK, Spain, Germany, and Japan which are tasked with developing products aimed specifically at these markets. The average development period for a new product is around twelve months, split into three stages. The first stage is to identify market trends and developments, including contact by the designers directly with the market; some are stationed in toy shops close to holidays, while others interview children. The second stage is the design and development of the product based upon the results of the first stage. As of September 2008 the design teams use 3D modelling software to generate CAD drawings from initial design sketches. The designs are then prototyped using an in-house stereolithography machine. These prototypes are presented to the entire project team for comment and for testing by parents and children during the "validation" process. Designs may then be altered in accordance with the results from the focus groups. Virtual models of completed Lego products are built concurrently with the writing of the user instructions. Completed CAD models are also used in the wider organisation, for marketing and packaging.
Attention then shifts to construction of the three aircraft. When I first spied this set I assumed that the two red jets were the same, but closer examination reveals a number of differences. First up is a red jet with a canard wing configuration as seen in the Saab Viggen amongst others. The lower fuselage is fashioned from a number of double and triple inverted 45 degree slopes with a pair of 1 x 14 Technic bricks running through the centre; there’s no obvious reason for Technic bricks to be used in this situation – standard 1 x 14 bricks would have done the job just as well - so I assume that LEGO just happened to have a bunch of them lying around…. A printed black 1 x 2 tile in the cockpit represents the instrument panel, while a substantial air intake is attached on either side of the fuselage at a 90 degree angle by way of brackets.
Airport Passenger Terminal with control tower and conveyor belt measures over 11” high, 12” wide and 4” deep. Airplane measures over 7” high, 18” long and 19” wide. Service car measures over 1” high, 2” long and 1” wide. Luggage trailer measures over 3" long, 1" high and 1" wide. Fuel trailer measures over 1” high, 3” long and 1” wide. Mobile stairway measures over 2” high, 2” long and 1” wide
I would also have liked a proper Ant-Man minifig – we get a micro Ant-Man, Giant-Man but not a regular-sized Ant-Man. There is a minifigure-sized Scott Lang hole in this set, and I think LEGO have wasted a great opportunity inserting a really popular and coveted minifigure into their flagship Civil War set. I would even gladly trade Cap and Bucky for one Ant-Man minifig.
Frequently Asked Questions | About Brickset | Privacy and Cookies | Affiliate Marketing Disclosure | Site Map | Contact Us LEGO, the LEGO logo, the Minifigure, and the Brick and Knob configurations are trademarks of the LEGO Group of Companies. ©2018 The LEGO Group. Brickset, the Brickset logo and all content not covered by The LEGO Group's copyright is, unless otherwise stated, ©1997-2018 Brickset ltd.