Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
The differences between the two jets mainly come on the top and rear of the builds. One has a larger single rear fin and two larger wings at the back, while the other has two smaller fins and the large wings positioned in the middle of the vehicle. The nose and cockpit areas are identical on both jets, and both come with stickers; the airshow logo on the wings, and a plane motif on the sides.
Airport Passenger Terminal with control tower and conveyor belt measures over 11” high, 12” wide and 4” deep. Airplane measures over 7” high, 18” long and 19” wide. Service car measures over 1” high, 2” long and 1” wide. Luggage trailer measures over 3" long, 1" high and 1" wide. Fuel trailer measures over 1” high, 3” long and 1” wide. Mobile stairway measures over 2” high, 2” long and 1” wide
The first few bags build the small truck with carts that you see on airport runways. The truck has a "follow me" sign that I confess I have not seen at any airport. There is also a fueling tank and a rolling staircase that sits next to the plane to allow for boarding. Both the tank and the staircase are additional carts for the truck, though I am guessing not both at the same time.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.