If you don’t own Black Panther Pursuit or any of the sets that included Captain America, I guess it would a plus getting the both of them in this set but Super Heroes collectors tend to be completionists, so I think that scenario will be particularly rare. I guess you could always sell your spares on the secondary market, but really, who wants to do that?
The build itself is good fun, as it should be, and engaging enough to be interesting. The only thing that I started to find a little boring was the Airport Control Tower, but then its top redeemed it. Naturally, the best thing to build is the Giant Man figure. The techniques used to make it posable, like a regular Lego minifigure, were brilliantly thought out. I hope to see more like this, perhaps in a Galactus set, although I doubt that’ll ever happen.
Agent 13 has a pretty plain appearance, with caramel-coloured wavy hair, and a black, spy-like top. Her torso has some nice details, with sharp, angular lines that all combine to form a rough outline of an upside down star. She has plain sand blue pants and rocks a sub-machine gun accessory. I like regular LEGO firearms, so it’s very nice to get one in this set as they’re fairly uncommon.
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
Last to be assembled is the hangar, which given its size is a surprisingly quick build – even though I’m a notoriously slow builder it took me barely ten minutes to put it together. The first step involves stacking dark bluish grey and orange plates and tiles to create a three-sided enclosure covering an area of 24 x 32 studs. Two side walls are then constructed from 1 x 6 x 5 rectangular girders topped off with dark bluish grey bricks and orange tiles, after which the roof is assembled, predominantly from a few large plates including a black 8 x 16 plate only previously available in two sets, and four dark bluish grey 6 x 24 plates which are only appearing in a set for the second time ever. A couple of stickers at the front of the structure identify it as an Airshow Hanger; to be frank, describing it as a hanger is probably exaggerating the case a bit as with its open front and rear it’s more akin to a large shelter.
We analysed reviews from different sources and found out that this domain has mostly negative reviews. Having lots of bad reviews can be really harmful to reputation of Lego-airport. As a result the domain may suffer traffic decrease and search engines penalties. We would strongly recommend that the site’s administrators pay more attention to opinions & suggestions of the users to meet their high expectations.
The box set weighs a little over 2kg and has about 694 pieces in total, including 6 minifigures: a pilot, 3 airport workers, a male and a female passenger. The whole build would get you almost an entire airport facade with a pretty big passenger plane, an airport/control tower build, and an airport service car that tows with it a luggage, fuel and and mobile stairway.
In December 2012, the BBC's More or Less radio program asked the Open University's engineering department to determine "how many Lego bricks, stacked one on top of the other, it would take for the weight to destroy the bottom brick?" Using a hydraulic testing machine, the engineering department determined the average maximum force a 2×2 Lego brick can stand is 4,240 newtons; since an average 2×2 Lego brick has a mass of 1.152 grams (0.0406 oz), according to their calculations it would take a stack of 375,000 bricks to cause the bottom brick to collapse, which represents a stack 3,591 metres (11,781 ft) in height.
So that's it... It's the first passenger airport set released in 6 years. It comes with a jet, 6 minifigures, a terminal, and some equipment for servicing the aircraft. Should you get it? After getting it, I'm glad I got it on sale, but I'm still not sure it was worth what I paid. I think it needs at least another terminal worker and then a pilot and flight attendant. Also you're paying for a lot of BURPs to help smooth the aircraft out. The age range listed is 6-12 years old so clearly it is not meant for old farts like me looking for a good building experience. However, if you're a LEGO CITY fan and you build your own MOCs to go with your city, it has some good additions. If you're looking to build an airport terminal of your own, you'll find some useful parts to make it realistic. We'll see if it takes another 6 years for an upgrade.
Bag 3 starts the aircraft and includes 3 minifigures (2 passengers and a pilot) The aircraft has the standard wings and fuselage sections. I am not a fan of the giant wing piece as it limits the number of seats. It does however help to make the aircraft more realistic. Given the size of the aircraft, there are only 5 seats for passengers which is rather disappointing.
Billund Airport had its beginning in 1961 when the son of the founder of the Lego Group, Godtfred Kirk Christiansen, established a private 800-meter long runway and hangar north of his factory in Billund. With Christiansen as a key driver, more of the neighbouring municipalities were included in the group of owners, and it was planned that the airport should be expanded to a regular public airport.