Stickers are used for decorations for the outside of the plane. I like how the stickers for the outside match colours with the piping on the plane. I found the sticker for the top of the door to be a little big; if you line up the orange on the bottom of the stickers with the orange on the plane the sticker overlaps a bit at the top. The stickers for the nose of the plane are not as difficult to apply as I thought they would be. They do seem a bit superfluous, though they do make the plane look nice. The plane is finished with the tail fin, that uses yet more stickers. It is interesting that this plane actually uses more stickers than the Friends plane does.
Correct - the hanger can only accommodate the biplane. That having been said, in order to accommodate the other aircraft too the hangar would have to be huge, with an enormous footprint, and a substantially increased parts count. As a result, I'd estimate a price up to double the current RRP which I suspect few of the target market would pay. LEGO therefore got the size of the hanger right IMHO.
Will agree with some other reviewers that some parts will fall off with normal-rough play. However, the attention to detail is pretty cool and almost makes up for it. The top is hard to take off and put on to move the minifigs. There is a TSA checkpoint, a conveyor belt for luggage, a rather impressive runway vehicle. Couple this with the cargo plane or another airplane set and some atraight road nameplates, you got an airport without spending a fortune.
The last of the three aircraft is a modern biplane. This incorporates a number of rare orange elements including right and left 8 x 3 wedge plates which make up the wings and have only previously appeared in three sets, a 3 x 4 wedge brick only previously found in two sets, and a 3 x 6 round half plate with a 1 x 2 cutout which has only previous appeared in a single set in this colour and which forms the tailplanes. Similar to the two jets the tail fin is stickered rather than printed, as are the pair of 1 x 4 x 1 panels making up the sides of the cockpit. Unlike the jets, however, the instrument panel is stickered, which seems odd as there are existing printed 1 x 2 light bluish grey tiles which could have done an acceptable job. There are also a pair of stickers which represent the engine exhausts and which are applied to a couple of modified 2 x 4 x 1 1/3 bricks with curved top which sit just behind the propeller; applying these neatly to the curved surface takes a steady hand, and that’s also the case for the pair of checkerboard stickers which are stuck onto the propeller cowl. As if stickered exhausts weren’t enough, there are also a couple of light bluish grey exhaust pipes with Technic pin which emerge from the propeller cowl and run along either side of the fuselage. They’re entirely superfluous given the presence of the stickered exhausts but they still look cool regardless!
In contrast to the first jet with its delta wing configuration and forward canard wings, the second jet features a more conventional straight wing configuration with tapered leading and trailing edges. As you might expect, construction of the fuselage of the second jet is in many ways similar to that of the first, although in order to accommodate twin exhausts the rear isn’t tapered, and the air intakes which flank the fuselage are of a different design.
@josekalel: I think the size of the terminal is kept in check for price reasons more than anything. This is a $100 set, and while bigger and pricier City sets exist, they tend to be few in number. What's more, the disadvantage to having a plane wide enough to seat two rows of passengers is that it inevitably takes up a big portion of the budget even for a larger set like this one. If the set were just the airport with no plane, then the terminal could probably be around twice this size at the very least… but then the set would not offer such a complete play experience.
Agent 13 has a pretty plain appearance, with caramel-coloured wavy hair, and a black, spy-like top. Her torso has some nice details, with sharp, angular lines that all combine to form a rough outline of an upside down star. She has plain sand blue pants and rocks a sub-machine gun accessory. I like regular LEGO firearms, so it’s very nice to get one in this set as they’re fairly uncommon.
The final two minifigures are the Biplane Pilot and the intrepid Wing Walker. Both of these minifigures share the same white torso which is printed with a flight suit design overlaid with dark red and bright light orange flames plus a logo over the left breast. The torso design is superb and it can at present only be found in this set. Both minifigures are provided with a reddish brown aviator cap and dark bluish grey goggles, and the pilot (below left) also gets an alternative to this headgear in the form of medium dark flesh mid-length hair which has only ever appeared in five sets in this colour.