After World City's discontinuation in 2004, it was replaced with City as System's primary town-life related theme in 2005. However, unlike its predecessor, it was not limited to sets involving rescue services like Police, Fire or Coast Guard, but also introduced the first new construction site related sets since the discontinuation of City Center in 2000. In 2006, the first new airport set that included the first jetway since 6597 Century Skyway (1994) was released, as well as the first new hospital since 6380 Emergency Treatment Center from 1987. These releases expanded City to a scope only comparable to the original Town theme, and in 2009 it even went slightly beyond that, by introducing the first farm-related System sets. Also, in that year, City followed this route to release more truly civilian town life sets such as 7641 City Corner and 7639 Camper. In 2010 City released more civilian sets including 8403 Family House and 8404 Public Transport. In 2011 City re-introduced the Space sub-theme along with some new Harbour sets. In the first wave of 2012, City had forest police and fire sets as well as some more commercial/civilian sets. The second wave of 2012 featured the introduction of the Mining theme and respective sets, as well as a hospital. In the winter of 2013, Police and Fire sets were once again focused on but, contrary to those released in the previous year, were set in the city. In the summer of 2013, the Coast Guard and Cargo subthemes were brought back.
Billund Airport (Danish: Billund Lufthavn) (IATA: BLL, ICAO: EKBI) is an airport in Denmark. Located 1 nautical mile (1.9 km; 1.2 mi) northeast[1] of Billund, it serves as one of the country's busiest air cargo centres, as well as a charter airline destination, although some regular airlines also offer flights there. Nearby Legoland Billund park is the largest tourist attraction in Denmark outside Copenhagen.
Since 1963, Lego pieces have been manufactured from a strong, resilient plastic known as acrylonitrile butadiene styrene (ABS).[12][30] As of September 2008, Lego engineers use the NX CAD/CAM/CAE PLM software suite to model the elements. The software allows the parts to be optimised by way of mould flow and stress analysis. Prototype moulds are sometimes built before the design is committed to mass production. The ABS plastic is heated to 232 °C (450 °F) until it reaches a dough-like consistency. It is then injected into the moulds at pressures between 25 and 150 tonnes, and takes approximately 15 seconds to cool. The moulds are permitted a tolerance of up to twenty micrometres, to ensure the bricks remain connected.[33] Human inspectors check the output of the moulds, to eliminate significant variations in colour or thickness. According to the Lego Group, about eighteen bricks out of every million fail to meet the standard required.[37] Lego factories recycle all but about 1 percent of their plastic waste from the manufacturing process. If the plastic cannot be re-used in Lego bricks, it is processed and sold on to industries that can make use of it.[38][39] Lego has a self-imposed 2030 deadline to find a more eco-friendly alternative to the ABS plastic it currently uses in its bricks.[40]
LEGO CITY has some recurring themes that can get old after a while and obviously are meant for younger LEGO fans.  The Fire and Police themes within CITY quickly come to mind as it seems like they have a new run each year.  The Airport theme is one of those that doesn't quite occur every year.  The last airport set was released in 2010 and was set #3182.  This year (2016) another airport was released.  #60104, Airport Passenger Terminal, was released on 1 August 2016 in the US.  It costs $99.99 in the US and contains 694 pieces or $0.144 per piece.  I picked the set up from Amazon at 20% off or $80 ($0.115 per piece).  Yay sales!  Onto the review...
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
We are a collective bunch of geeks who love to share our passion with the rest of the world. Just like the Beholder we have adopted as our mascot, we have both depth and width of geeky topics we cover. By visiting this page, you declare yourself one of us! If you have grown up with a steady diet of all things related to video games, Star Wars, Star Trek, sci-fi, gadgets, toys, Transformers one way or another, this will be your second home.
Other airlines offering intercontinental connections to Copenhagen are SAS's Star Alliance partners Singapore Airlines (to Singapore), Air Canada (to Toronto) and Thai Airways (to Bangkok Suvarnabhumi and Phuket), as well as competing SkyTeam carrier Delta with a seasonal connection to JFK and Pakistan International Airlines to Islamabad and Lahore.
Minifigures are the real draw, although we’ve seen most of these characters before, but the completist will want them in their updated costumes. Among the figures are Iron Man, War Machine, Scarlet Witch, Agent 13, Captain America, Winter Soldier, an Ant-Man micro-figure and of course the Giant-Man Brick built figure. These are all fantastic, and it’s the first outing for the Agent 13 figure. The printing on these figures is excellently detailed; in particular Iron Man and War Machine, who both get leg printing, are fantastic. I’m one-hundred percent sure, but Agent 13 has what looks like a new hairpiece that is really well sculpted. And this time around, Scarlet Witch gets correctly coloured hex blasts. If there is a slight downer on the mini,figure side of things, it’s Captain America. Sadly we’ve seen it all before and despite the new detailed printing on his torso, he just looks really plain when stood next to the others in this set.
The build itself is good fun, as it should be, and engaging enough to be interesting. The only thing that I started to find a little boring was the Airport Control Tower, but then its top redeemed it. Naturally, the best thing to build is the Giant Man figure. The techniques used to make it posable, like a regular Lego minifigure, were brilliantly thought out. I hope to see more like this, perhaps in a Galactus set, although I doubt that’ll ever happen.
The body of the plane is built with five seats for passengers. The wings are added next with what I think are filler stickers added to the top of the wings. There is a small galley with sink and oven in the front of the plane right behind the cockpit. The cockpit uses only one sticker to show navigation equipment - the other is printed, which is always welcome (though not a new piece). A lavatory is installed in the back, and then the inside is complete. There is an odd choice for the door to the lav - a swinging door. Not much opportunity for privacy!
I purchased this set the day it was released for my LEGO City, as an upgrade from my previous airport (10159 Airport from 2004). First off, the build is great and although it's not very challenging, it's exciting to see the plane come to life and the use of the big plane pieces (eg. the nose, the wings, the tail etc.) was new to me, though I know there have been a number of planes in the past that use these pieces. There are 4 instruction booklets (2 for the plane, one for the airport, and one for the luggage/fuel/stairs car), 8 numbered bags, and two separate bags with the bigger pieces in. This makes the build very easy to follow. The completed set is very grand (especially the plane) in scale, and great looking. It's nice to see that a different colour scheme been used for the plane as opposed to the usual red and white or blue and white colours as seen in previous sets. The plane is HUGE, with a wingspan of around 2 32-wide baseplates (bare this in mind if you want to make a runway). However, despite its huge size, the inside of the plane is very bare. There are 5 seats for the passengers, another one facing backwards which I presume is for the cabin crew (although there isn't a cabin crew minifigure, which would have been a nice addition), and two seats in the cockpit. There's a tiny bathroom at the back of the plane, and a small galley area at the front with a sink and cupboard. There's easily room for a sixth chair in the plane, which I think should have been included, and the space within the plane could've been arranged better to fully optimise the area. The airport terminal has a very nice modern look, and includes the revolving door, tower, waiting area, security scanner and check in desk with luggage conveyor. Although this sounds like a lot of features, the inside of the terminal is, again, very bare and the space could've been used better. There are only 4 seats in the waiting area, and a lot of the space is taken up by the revolving door. The operational conveyor belt for the luggage is a nice touch, though, and there is a fair bit of playability within. The service car is a nice addition to this set and gives it more playability. All the trailers (fuel, stairs and luggage) connect together and attach to the service car, which has a really cool "follow me" sign on the back. This is a really nice addition to the set. Overall, I really like this set because of how it looks and because there's plenty of opportunity for play, but I think a lot more thought could've gone into maximising the space within the plane and the airport. Some more minifigures would have been good, such as a member of the cabin crew, a check-in clerk and a security officer. The value for money is okay with this set, as you do get a lot of big pieces, but the bare interiors are a little disappointing for the price you pay.
I'm not sure what to make of the set yet. I like the planes (although that biplane really doesn't need the bubble canopy). The idea of adding a hangar is interesting and I don't mind that it's a bit open. But the fact that it'll only house one of the three planes is annoying. Having said that, I'm not sure what you could do about it. Tripling the hangar would make it big and boring and push the price up. Could they have done two planes and a double hangar?

Domain Administrator of LEGO Juris A/S failed to keep it trustworthy. Please be warned that to describe security status of Lego-airport.com we use data openly available on the Web, thus we cannot guarantee that no scam sites might have been mistakenly considered legit and no fraud or PC issues may occur in this regard. But usually the crowdsourced data we have is pretty accurate. Let's see it below.
We are a collective bunch of geeks who love to share our passion with the rest of the world. Just like the Beholder we have adopted as our mascot, we have both depth and width of geeky topics we cover. By visiting this page, you declare yourself one of us! If you have grown up with a steady diet of all things related to video games, Star Wars, Star Trek, sci-fi, gadgets, toys, Transformers one way or another, this will be your second home.

Will agree with some other reviewers that some parts will fall off with normal-rough play. However, the attention to detail is pretty cool and almost makes up for it. The top is hard to take off and put on to move the minifigs. There is a TSA checkpoint, a conveyor belt for luggage, a rather impressive runway vehicle. Couple this with the cargo plane or another airplane set and some atraight road nameplates, you got an airport without spending a fortune.
Last to be assembled is the hangar, which given its size is a surprisingly quick build – even though I’m a notoriously slow builder it took me barely ten minutes to put it together. The first step involves stacking dark bluish grey and orange plates and tiles to create a three-sided enclosure covering an area of 24 x 32 studs. Two side walls are then constructed from 1 x 6 x 5 rectangular girders topped off with dark bluish grey bricks and orange tiles, after which the roof is assembled, predominantly from a few large plates including a black 8 x 16 plate only previously available in two sets, and four dark bluish grey 6 x 24 plates which are only appearing in a set for the second time ever. A couple of stickers at the front of the structure identify it as an Airshow Hanger; to be frank, describing it as a hanger is probably exaggerating the case a bit as with its open front and rear it’s more akin to a large shelter.
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
×