Manufacturing of Lego bricks occurs at several locations around the world. Moulding is done in Billund, Denmark; Nyíregyháza, Hungary; Monterrey, Mexico and most recently in Jiaxing, China. Brick decorations and packaging are done at plants in Denmark, Hungary, Mexico and Kladno in the Czech Republic. The Lego Group estimates that in five decades it has produced 400 billion Lego blocks.[41] Annual production of Lego bricks averages approximately 36 billion, or about 1140 elements per second. According to an article in BusinessWeek in 2006, Lego could be considered the world's No. 1 tire manufacturer; the factory produces about 306 million small rubber tires a year.[42] The claim was reiterated in 2012.[43]
The remainder of the build is the control tower and terminal building. First there is a metal detector screener leading to the waiting/secure area of the airport, which seems taller than it needs to be for the minifigures. I think the same effect could have been made with half the height, except that would not allow for an impressive height for the overall tower. However it does seem to be similar to many modern airports with the high ceilings. This area also seems to be someplace to check luggage as evidenced by the rather nifty conveyor belt that comes in a full part. The moving parts of the set include a revolving door (a very tall one, for the first floor) that leads from the secure area of the airport out to the tarmac, and of course the conveyor belt.
In contrast to the first jet with its delta wing configuration and forward canard wings, the second jet features a more conventional straight wing configuration with tapered leading and trailing edges. As you might expect, construction of the fuselage of the second jet is in many ways similar to that of the first, although in order to accommodate twin exhausts the rear isn’t tapered, and the air intakes which flank the fuselage are of a different design.
As is the norm with LEGO sets these days, there are a fair few stickers in use for this item. I’m still not a fan of their use, but at this point in time, it is something I have come to expect and just get on with it now. In their defence, they do add to the overall presentation, making it that little bit harder to complain. As I said, this is my favourite of the three planes in the set, mainly because it looks superb and offers a great build experience. Seriously, I had so much fun building this. The instructions – as always – are clear, and it is not going to provide any major issues. Stability-wise, there are no concerns here, with the finished product very sturdy and, as proved by my daughter, can handle itself when being flown around the room by an excited seven-year-old. One minifigure can be seated at the controls, with suitable space for application and removal. The other pilot has its place on the top of the plane, with a single piece of black fencing to provide support for the death-defying pilot.
Colour-wise, it is mainly yellow, with only a dash of green and red, and a little more white, there to break it up. The worker has space to stand and drive the vehicle, and has a walkie talkie attached on the side of the car. Around the other side is a coiled-up, what I assume is a, fuel pump. It looks pretty good when coiled up on the side of the car. Stickers come into use again here, this time for the number plates.
×